Jump to content

Sjn5188 New shrimp setup.


sjn5188

Recommended Posts

So now it was time to start the plumbing for the tanks, each divided section will have its own intake and out take. I used 25mm pipe then a stainless strainer for the intake and 19mm for the return pipe then reduced to 13mm for the outlet. The bottom half of the bulk head actually sits between the tank and the board so all I have to do is just screw the top half of the bulkhead into each half.

shrimpoutlet3_zpsef5f714b.jpgshrimpoutlet2_zps263c6590.jpgshrimpoutlet_zps76bf6c61.jpg

Link to comment
Share on other sites

After the bulk heads I added 25mm elbows or tee pieces, depending on their position than connected them all together and ran one 25mm return to the sump.

shrimppipe4_zps212dde98.jpgshrimppipe2_zpsc6c89fa1.jpg

Link to comment
Share on other sites

I had a problem with the strainers sitting too low in the tank which caused the water to only come up about 40mm from the top. I couldn't raise them because of the lids and I wanted to raise the water levels in the tanks. So to fix the [roblem I cut a piece of pvc pipe that fitted over the strainers and sat them ontop. This raised the level of the water without even having to glue the pipe in place.

shrimppipe3_zps8b9c8760.jpg

Link to comment
Share on other sites

Great work, coming along very quickly...is there a diff, or adv/disadv or having the overflow on the side/back of the tank, rather then the bottom?

Link to comment
Share on other sites

Great question Marcus, I'm wondering the same thing. After speaking with a couple of people the main issue I have heard is that the side or rear mounted bulkhead may block easier, but I'm willing to hear more from other people that have been there and done that.

Link to comment
Share on other sites

Great work' date=' coming along very quickly...is there a diff, or adv/disadv or having the overflow on the side/back of the tank, rather then the bottom?[/quote']Yep thats right with the side mount overflow you only have water going into about half the diameter of the bulkhead, but with a bottom mount you have water that can flow around the total area of the bulkhead making it drain more efficiently. both ways have there pro's and cons. Side mount you loose space at the back or side of the tank due to plumbing. but with bottom mount you dont. but on the other hand you loose space underneath the tank with bottom mount's and none with side. I have used both and I like both setups. You just need to think about what will work for you in regards to space, looks and flow rates.
Link to comment
Share on other sites

  • 1 month later...

The tank is now set up and running with shrimp. Just building up my stocks and quality before I start any breeding programs. I hooked up a 5m led strip lighting for the room you can see a one metre strip under the top tank.

20130208_172344_zps1e269ee7.jpg

some pics of my shrimp. Big thanks to Dean for helping me out with some new shrimps to build my stocks up.

20130208_172322_zpsed4ffbbb.jpg20130208_172311_zpsbb20c868.jpg20130208_172305_zpsad75a39d.jpg

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Join Our Community!

    Register today, ask questions and share your shrimp and fish tank experiences with us!

  • Must Read SKF Articles

  • Posts

    • ngoomie
      Alright, I've done a bit more research on gentian violet's cancer-causing potential but I haven't yet done research on malachite green's to compare. But from reading the California propositon 65 document about GV (North Americans incl. some Canadians will recognize this as the law that causes some products they buy to be labelled with "known to the state of California to cause cancer", including the exact product I bought) it seems that the risk of cancer is related to internal use, either injection or ingestion. Speaking of ingestion, I think GV bans mainly relate to its use in treating fish/shrimp/etc. which are intended for human consumption, because of the above. And in countries where GV isn't banned for this purpose, it does seem to get used on various species of shrimp without causing any issue for the shrimp themselves (at least enough so for shrimp farming purposes). See the following: In February, the FDA Began Rejecting Imported Shrimp for Gentian Violet and Chloramphenicol (2022 article by Southern Shrimp Alliance) FDA Starts New Calendar Year by Refusing Antibiotic-Contaminated Shrimp from Three BAP-Certified Indian Processors and Adding a BAP-Certified Vietnamese Processor to Import Alert (2024 article by Southern Shrimp Alliance) Southern Shrimp Alliance and some other organizations have tons of other articles in this vein, but I'd be here for a while and would end up writing an absolutely massive post if I were to link every instance I found of articles mentioning shrimp shipments with gentian violet and/or leucogentian violet registering as contaminants. That being said, I know shrimp farmed for consumption and dwarf shrimp are often somewhat distantly related (in fact, the one time a shrimp's species name is listed that I can see, it's the prawn sp. Macrobrachium rosenbergii, who at best occupies the same infraorder as Neocaridina davidi but nothing nearer), but this at least gives a slightly better way of guessing whether it will be safe for aquarium dwarf shrimp or not than my bladder snail anecdote from the OP.
    • sdlTBfanUK
      I would hazard a guess that perhaps those eggs were unfertilized and thereby unviable? Did the eggs change colour, usually yellow to grey as the yolks used up, or any eyes in the eggs. Is your water ok, using RO remineralised and the parameters in range, as I have heard others say that if the water isn't good it can 'force' a molt? How is it going overall, do you have a good size colony in the tank, you may have reached 'maximum occupancy' as a tank can only support so many occupants.
    • beanbag
      Hello folks,  The current problem I am having is that my Taiwan bee shrimp are molting before all their eggs have hatched.  Often the shrimp keep the eggs for 40+ days.  During that time, they lose about half or so, either due to dropping or duds or whatever.  Shortly before molting they look to have about a dozen left, and then they molt with about half a dozen eggs still on the shell.  Then the other shirmp will come and eat the shell.  These last few times, I have been getting around 0-3 surviving babies per batch.  I figure I can make the eggs hatch faster by raising the water temperature more (currently around 68F, which is already a few degrees higher than I used to keep it) or make the shrimp grow slower by feeding them less (protein).  Currently I feed Shrimp King complete every other day, and also a small dab of Shrimp Fit alternating days.  Maybe I can start alternating with more vegetable food like mulberry?  or just decrease the amount of food?
    • ngoomie
      Yeah, cancer risk was a thing I'd seen mentioned a lot when looking into gentian violet briefly. I kinda just figured it might only be as bad as the cancer risk of malachite green as well, but maybe I should look into it more. I've been doing a pretty good job of not getting it on my skin and also avoiding dunking my unprotected hands into the tank water while treating my fish at least, though. Maybe I'll just not use it once I'm done this course of medication anyways, because I know a store I can sometimes get to that's pretty distant carries both malachite green and methylene blue, and in pretty large quantities.
    • jayc
      Can't help you with Gentian Violet, sorry. It is banned in Australia violet for potential toxicity, and even possible cancer risks. I thought it was banned in Canada as well. At least, you now know why there isn't much info on gentian violet medication and it's use. But keep an eye on the snails after a week. If it affects the snails, it might not kill them immediately. So keep checking for up to a week. Much safer options out there. No point risking your own life over unsafe products.
×
×
  • Create New...