Search the Community
Showing results for tags 'plumbing'.
-
Hi all, I am in need some advice, I've no experience with plumbing whatsoever (with the exception of using canister filters with chillers if that counts) so please bear with me if my questions seem silly or obvious! I came across 2 cheap 4 foot tanks with holes drilled already in the base of them that I am hoping to use. There are only a couple of minor scratches here and there and the only damage is on a back corner where the bezel is chipped - I intend to silicone this inside and out to be safe. Anyway I have a few points that I'd really love help to address. - How best to plumb these 2 sitting at the same height and integrate a sump. - Is it feasible to use 2 eheim canisters with a my chiller connected to a sump? When I only ran one canister the flowrate was not quite enough and the chiller was turning on and off too frequently as a result. Do I have to just bite the bullet and fork out money on a pump instead? - Opinions on how best to divide the setup into several bays for different colonies. Currently I am looking at following Paul Minett's lead using tropical flyscreen which has less than 0.4mm aperture but he has told me there is still the occasional fugitive baby. Thanks in advance, once I actually start doing anything on this setup I will post the progress in a journal here. Once again NB I am totally clueless so I'd appreciate it if you could dumb down your suggestions for me :-) Love and peace Will