Jump to content

Benebachi Bee Max


mst_mugen

Recommended Posts

Hey all,

 

Just a quick question. How do you guys go about dosing Bee Max during your weekly dosing regime?

 

I find Bee Max to be small pieces clumped together as oppose to a fine powder. So when I dose I always get pieces stuck around my inlet, floating on the surface of the tank and floating around inside the tank.

 

I have also tried mixing the Bee Max first in a small container with tank water before dosing it into the thank. Unfortunately, the same thing happens.

 

How do you guys get around this? Is the Bee Max meant to be a fine powder or small clumps?

 

Thanks! :)

Link to comment
Share on other sites

Thank you for the post - it was a very informative thread

 

What exactly did you want to bring my attention to? The shrimp eat the clumps of Bee Max? Besides that, not too sure if the thread you posted actually answers my question.

Link to comment
Share on other sites

Any fine powder will clump when added to water. If you are really concerned, you can add the powder and some tank water to a blender, and blend on high for a minute or two. We use this method at work regularly for fine algae powders and pastes, but I'm not sure how practical it will be for you given you probably wont be using very much powder.

Link to comment
Share on other sites

Hello mugen,

I also put some tank water in a cup and put the bee max in and mix it up with a spoon. I then let it sit for 30 mins or so. I'll give it another stir then slowly add to. The tank.

I would say about 99% of it sinks down and doesn't clump. There are still some bits that float. I hope this helps

Link to comment
Share on other sites

Many thanks for your responses guys!

 

I guess my main problem (maybe) is that my Bee Max isn't a fine powder straight from the packet (i.e. the consistency of the content varies in size and texture). There seems to be larger pieces which aren't clumped up powder. It is these larger pieces that float around in the tank and on the surface - the powder falls straight to the bottom of the tank.

 

Disciple: I will try letting the Bee Max set for longer before I add it to the tank - hopefully that reduces the amount of large particles I get floating around in the tank and on the surface. Thanks.

Link to comment
Share on other sites

I always add it to some tank water first, let it soak & then suck it up with a turkey baster, then squirt it to the bottom of the tank, this way I get minimal floating bits.

A mortar & pestle sounds like a good idea too. :thumbsu:

Link to comment
Share on other sites

You might need to get a cheap mortar and pestle and grind it up

 

I always add it to some tank water first, let it soak & then suck it up with a turkey baster, then squirt it to the bottom of the tank, this way I get minimal floating bits.

A mortar & pestle sounds like a good idea too. :thumbsu:

 

Thanks for the suggestions guys... looks like I have some shopping to do LOL

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Join Our Community!

    Register today, ask questions and share your shrimp and fish tank experiences with us!

  • Must Read SKF Articles

  • Posts

    • sdlTBfanUK
      Thats a great photo, beautiful blue bolt, I hope it survived the molt without dropping the eggs! I think I can just about see some black dots (eyes) on the central egg but can't be 100% sure. I used to (and plan to again) do weekly water change of 10-15% but if you do too large or quick (not drip in new water) that would likely trigger a molt. What KH are they in, my new setup is sitting at (and refusing to budge) KH 3 and PH 7.5 so I may have to settle for neocaridina shrimp this time as opposed to the caridina I want, though not looking/deciding just yet, give the tank a bit more of a run in! Tap water here starts at kH 14, tds 320, when filtered goes to KH 0 and PH 6 but when put in the tank keeps going to KH3 and PH 7.5 despite 3 x 50% water changes???? You may be at 'maximum capacity' with only 20L tank especially if the tank is a cube type rather than shallow type?
    • beanbag
      Right now this tank only has blue bolts and golden bee (red bolts?).  The eggs start off all brown, but at the end, I notice that some are kind of a clear pink-ish color.  So I don't know if that is the egg color of dud or golden bee.  Picture of shrimp only about half hour before molting. The water is always RO + remineralizer, so it should be ok. The tank seems to still be on a "good streak" ever since I started the regimen of weekly water change, monthly gravel vac and plant trim.  The point being to keep the amount of waste low and removing moss / floating plants so that the nitrates go towards growing algae.  At one point, I had three berried females, but only netted about half dozen babies by the end, due to this early molting problem.  There might be about 30-40 shrimp total in 5 gallons, but still very few full-sized adults.
    • ngoomie
      Alright, I've done a bit more research on gentian violet's cancer-causing potential but I haven't yet done research on malachite green's to compare. But from reading the California propositon 65 document about GV (North Americans incl. some Canadians will recognize this as the law that causes some products they buy to be labelled with "known to the state of California to cause cancer", including the exact product I bought) it seems that the risk of cancer is related to internal use, either injection or ingestion. Speaking of ingestion, I think GV bans mainly relate to its use in treating fish/shrimp/etc. which are intended for human consumption, because of the above. And in countries where GV isn't banned for this purpose, it does seem to get used on various species of shrimp without causing any issue for the shrimp themselves (at least enough so for shrimp farming purposes). See the following: In February, the FDA Began Rejecting Imported Shrimp for Gentian Violet and Chloramphenicol (2022 article by Southern Shrimp Alliance) FDA Starts New Calendar Year by Refusing Antibiotic-Contaminated Shrimp from Three BAP-Certified Indian Processors and Adding a BAP-Certified Vietnamese Processor to Import Alert (2024 article by Southern Shrimp Alliance) Southern Shrimp Alliance and some other organizations have tons of other articles in this vein, but I'd be here for a while and would end up writing an absolutely massive post if I were to link every instance I found of articles mentioning shrimp shipments with gentian violet and/or leucogentian violet registering as contaminants. That being said, I know shrimp farmed for consumption and dwarf shrimp are often somewhat distantly related (in fact, the one time a shrimp's species name is listed that I can see, it's the prawn sp. Macrobrachium rosenbergii, who at best occupies the same infraorder as Neocaridina davidi but nothing nearer), but this at least gives a slightly better way of guessing whether it will be safe for aquarium dwarf shrimp or not than my bladder snail anecdote from the OP.
    • sdlTBfanUK
      I would hazard a guess that perhaps those eggs were unfertilized and thereby unviable? Did the eggs change colour, usually yellow to grey as the yolks used up, or any eyes in the eggs. Is your water ok, using RO remineralised and the parameters in range, as I have heard others say that if the water isn't good it can 'force' a molt? How is it going overall, do you have a good size colony in the tank, you may have reached 'maximum occupancy' as a tank can only support so many occupants.
    • beanbag
      Hello folks,  The current problem I am having is that my Taiwan bee shrimp are molting before all their eggs have hatched.  Often the shrimp keep the eggs for 40+ days.  During that time, they lose about half or so, either due to dropping or duds or whatever.  Shortly before molting they look to have about a dozen left, and then they molt with about half a dozen eggs still on the shell.  Then the other shirmp will come and eat the shell.  These last few times, I have been getting around 0-3 surviving babies per batch.  I figure I can make the eggs hatch faster by raising the water temperature more (currently around 68F, which is already a few degrees higher than I used to keep it) or make the shrimp grow slower by feeding them less (protein).  Currently I feed Shrimp King complete every other day, and also a small dab of Shrimp Fit alternating days.  Maybe I can start alternating with more vegetable food like mulberry?  or just decrease the amount of food?
×
×
  • Create New...