Jump to content

Help please with tank construction questions


Noel

Recommended Posts

I plan to build multiple glass tanks for a tank rack and have no previous experience. Each tank will have length x width x height measurements equal to 45cmx20cmx30cm 

Each tank will be constructed with its side panes on top of the base plane. The rear pane (one of the two shorter side panes) will have a hole drilled into it to accommodate a bulkhead.

I would appreciate advice with the following:

1.    Is 6mm glass all round necessary because of the bulkhead, or can I go thinner?

 

2.    Should the longer side panes span the length of the tank and the shorter panes fit inside them or would it be stronger for the bulkhead if the shorter panes span the width of the tank and the longer sides fit inside them?

 

3.    I have read elsewhere that the inside panes should be cut to a size to allow for an silicone fillet of depth 1mm or more between the panes depending on the tank size and that this provides the structural seal while the silicone inside the tank protects this seal. What fillet depth should I allow for?

Edited by Noel
one sentence did not make sence
Link to comment
Share on other sites

  • 1 month later...

1) I wouldn't go any thinner than 6mm glass.

2)  the shorter panes span the width of the tank and the longer sides fit inside them

3) 1mm depth should be enough for the size of tanks you are planning.

Link to comment
Share on other sites

What he said. If you plan on taking macro photos don't go too thick either. I've got 10mm thick glass which causes too me refraction for my macro lens to get the sort of macro shots I get on my smaller tanks with 6mm glass.

Link to comment
Share on other sites

Just some advice when building either the rack or the tanks leave enough space to enable to insult your tanks with polystyrene sheeting, or similar, on the back of the tank and sides, mainly for winter I also place a cut to size sheet on top of the tanks at lights out.

In summer you can store these cut offs in your roof, a little more insulation in the roof for summer. 

I remove the side sheets in summer to allow for air circulation around the tanks as I have a ceiling fan to help with cooling. I leave the back sheets on as I have sceneries glued on them from my fish keeping days.

Link to comment
Share on other sites

5 hours ago, zn30 said:

leave enough space to enable to insult your tanks with polystyrene sheeting

HAHA, I just saw this. 

 

Insult your tanks. I'd like to see a vid of you doing that!!

 

 

Link to comment
Share on other sites

4 hours ago, jayc said:

HAHA, I just saw this. 

Insult your tanks. I'd like to see a vid of you doing that!!

LOL spell check we just rely on it too much.

However I'm sure we have all insulted our tanks every now and then, and wow and behold anyone standing by giving advice, as my wife shakes her head and glares at me.

Link to comment
Share on other sites

LOL AHAHAHAHAH

 

Polystyrene insults tank.

  • Like 1
Link to comment
Share on other sites

Just don't forget to give your tank the sheets!

image.jpeg

  • Like 2
Link to comment
Share on other sites

Noel, I've just seen this thread. Did you build the tanks yet? One critical factor that nobody mentioned is that the base should be floating between the sides, not supporting them as you described. If you've already built them, well you might be ok because they're small and there's no real structural stress. Good luck! But for future reference, that is not the way to build a glass aquarium. I'm sure there's plenty of online resources that illustrate the right way. 

  • Like 2
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Join Our Community!

    Register today, ask questions and share your shrimp and fish tank experiences with us!

  • Must Read SKF Articles

  • Posts

    • beanbag
      Hello folks,  The current problem I am having is that my Taiwan bee shrimp are molting before all their eggs have hatched.  Often the shrimp keep the eggs for 40+ days.  During that time, they lose about half or so, either due to dropping or duds or whatever.  Shortly before molting they look to have about a dozen left, and then they molt with about half a dozen eggs still on the shell.  Then the other shirmp will come and eat the shell.  These last few times, I have been getting around 0-3 surviving babies per batch.  I figure I can make the eggs hatch faster by raising the water temperature more (currently around 68F, which is already a few degrees higher than I used to keep it) or make the shrimp grow slower by feeding them less (protein).  Currently I feed Shrimp King complete every other day, and also a small dab of Shrimp Fit alternating days.  Maybe I can start alternating with more vegetable food like mulberry?  or just decrease the amount of food?
    • ngoomie
      Yeah, cancer risk was a thing I'd seen mentioned a lot when looking into gentian violet briefly. I kinda just figured it might only be as bad as the cancer risk of malachite green as well, but maybe I should look into it more. I've been doing a pretty good job of not getting it on my skin and also avoiding dunking my unprotected hands into the tank water while treating my fish at least, though. Maybe I'll just not use it once I'm done this course of medication anyways, because I know a store I can sometimes get to that's pretty distant carries both malachite green and methylene blue, and in pretty large quantities.
    • jayc
      Can't help you with Gentian Violet, sorry. It is banned in Australia violet for potential toxicity, and even possible cancer risks. I thought it was banned in Canada as well. At least, you now know why there isn't much info on gentian violet medication and it's use. But keep an eye on the snails after a week. If it affects the snails, it might not kill them immediately. So keep checking for up to a week. Much safer options out there. No point risking your own life over unsafe products.
    • ngoomie
      Hello! I have a tank that currently does not contain shrimp, but does contain neon tetras which I am currently treating for Ich, as well as some bladder snails. Shrimp will be a later addition, likely cherry shrimp but I'm still doing research just to be sure. Initially I'd intended to buy some sort of Ich-fighting product that contains malachite green after doing a decent bit of research on it, most of which indicated that it should be shrimp-safe so I'd be good if I ever needed to use it again once shrimp were actually introduced (though I should note I'm aware shrimp can't get Ich, I'm more wondering in case the tetras could get Ich again, or something else that responds to similar medication). I ended up not being able to find any MG-containing products without either having to travel quite far or wait multiple days for delivery (which I was worried could lead the Ich to be fatal), and ended up picking up 'Top Fin Ick Remedy', a product that contains gentian violet which is a triarylmethane dye like malachite green. The bottle has two slightly differently worded warnings about its use with invertebrates ("not recommended for" and "not safe for" respectively), but when I'd been researching malachite green, I'd also heard of products that contain MG but not any other ingredients that would be harmful to inverts still being branded with warnings that they could be harmful, just as a "just-in-case" since the manufacturer didn't test it on any inverts, and I'm wondering if maybe it could be a similar situation here. I'm having a very very hard time finding information about gentian violet's use in fishkeeping at all though, it seems currently extremely uncommon. What I will say though is that I'm on day 2 of treating my tetras with it, and the bladder snails seem just fine -- in fact today I noticed what looked to be a bladder snail that appeared to be newly hatched (because of its size) that I hadn't seen before that was zipping around the tank without issue. But obviously, shrimp are not snails, and bladder snails are also notoriously hardy little guys, so what I'm seeing right now could easily be totally inapplicable to cherry shrimp. It might even be inapplicable to other species of snails, for all I know. Has anyone else here ever used anything that contains gentian violet in a tank that actually does contain shrimp? Were they okay, or should I make sure to not use it once shrimp are added?
    • sdlTBfanUK
      https://www.youtube.com/watch?v=58BrDSEY8KE  
×
×
  • Create New...