Hi everyone,I have just completed my first shrimp rack but are unsure about my refugium design.The first baffle in all three compartments are equal and the other three are stepped down.My question is am I better off reducing the height of the first baffle so that is only slightly higher than the second one thus increasing water flow or will it make no difference.Another option is to put a perspex plate,at a 45 degree angle,with holes drilled in it to distribute the oxygenated water more evenly.

Look forward to your input.

 

Cheers Mark.

Edited April 19, 201511 yr by Mark49

It won't make much difference. If it's the sound of the water you are worried about, I had the same issue. I just got a big piece of course sponge & cut it to slightly wider than the tank & wedged it in the sump so the sponge was just above the waterline. This way the water falls on to the sponge & it stops the sound. Hope this helps.

Thanks Squiggs.

Looks Good,

 

Have you worked out the amount of water the sump has to hold in a power out?? you look like you are clear. Lots come unstuck when the power goes out and the sump over flows

 

Do as Mr Squigley said and that kills the noise, easy as.

 

A good Bio mass is 50% shade cloth, works a treat and is all I use and easy to clean. OH I use a pre filter at first contact in the first chamber, Sheets of toy animal stuffing from Spot light cheep and easy and polishes the water well

 

There is enough oxygen in the water through the sump action, if you want more a air stone under each chamber works a treat.

 

Bob

Edited April 20, 201511 yr by northboy