Jump to content

sdlTBfanUK

Recommended Posts

I have been using one of these for years. It only holds 4 liters at a time so probably only suitable for smaller aquarims, mine are 30L. There is a tap so you can adjust the speed of the drips, or even slow flow. I use it for water changes and acclimatising new shrimp. Made in USA www.zoomed.com so must be available there, and meant for reptiles?

https://amzn.to/2Dc3oVp

The link is just so you can see the product from the UK place I get them.

Link to comment
Share on other sites

There are some aquarium based ones as well. Here's a few types...

 

FA18X Aquarium Acclimation System
UP aquarium drip bucket
Accudrip - Drip Acclimation Kit

 

I would like to get the UP Aquarium Drip Buckets. There's two sizes and I'd probably end up with both... they fit on the corner of tanks with 90° angles  Standard square/rectangular tanks from pet stores.

Link to comment
Share on other sites

I have been to US many times, so not surprised you have a lot of alternative products available there!!! It is good that you list them here so people know about what is out there, even if they can't get ALL of them where they live etc. The one I featured only holds 1 US gallon so only any good for small tanks. I expect the ones you list may be LARGER capacities - isn't everything bigger in the US.........

I like the sound of the one that sits on the corner of the tank, the big dripper can either be hung by the handle above the tank, or, as I, sat on the cover of the tank with the pipe poked through the gap around the cover etc.

Link to comment
Share on other sites

Actually, the UP Aquarium Drip Bucket isn't readily available. It's not easy to find more than one person, three if I'm that lucky, who carry it/sell it here.


Most of the good shrimp products come from Asia or Germany...

Link to comment
Share on other sites

There is nothing more satisfying than DIY, and building your own water change dripper.

water.png.e41135121c5cb470304d2c51480ddbb3.png

I use an old 4L spring water bottle that has one of those spouts that have a tap on it.

Cut a hole on the top to make adding water into the bottle easier. (as per the picture below).

water2.png.8b11836dfc57cccc662f521f18ab4aea.png

And just turn the tap on ever so slightly until a required drip rate is achieved.

Cost: $4 for the water bottle, which was used at a picnic. 

 

Edited by jayc
  • Like 1
Link to comment
Share on other sites

8 hours ago, jayc said:

There is nothing more satisfying than DIY, and building your own water change dripper.

water.png.e41135121c5cb470304d2c51480ddbb3.png

I use an old 4L spring water bottle that has one of those spouts that have a tap on it.

Cut a hole on the top to make adding water into the bottle easier. (as per the picture below).

water2.png.8b11836dfc57cccc662f521f18ab4aea.png

And just turn the tap on ever so slightly until a required drip rate is achieved.

Cost: $4 for the water bottle, which was used at a picnic. 

 

Very ingenious and a lot cheaper than buying something made specifically for the purpose. I haven't seen anything like this in the UK, we never get the range/variety that large countries like US and Australia get. It is good to give people all the alternatives and then they can decide what they want and what is available to them.

I'm sure there will be lots of people interested in your water container. Is it easy to fill or do you use a funnel? Or have you cut a hole in the side/top (the black patch in the photo)? How big is it in water capacity?

Link to comment
Share on other sites

On 9/21/2018 at 6:20 PM, sdlTBfan said:

Is it easy to fill or do you use a funnel? Or have you cut a hole in the side/top (the black patch in the photo)? How big is it in water capacity?

Very easy to fill. No funnel needed. The hole is as show in the picture, the black patch is the hole, yes. 

That bottle is 4 Litres. 

 

Link to comment
Share on other sites

  • 7 months later...

Just thought I would add a picture of the product and how I use it to get maximum water out of the dripper?

IMG_20190503_103448.thumb.jpg.95189e7e5b716491473fa50eb6432dad.jpg

Simon

Link to comment
Share on other sites

On 9/20/2018 at 10:48 PM, Zoidburg said:

Actually, the UP Aquarium Drip Bucket isn't readily available. It's not easy to find more than one person, three if I'm that lucky, who carry it/sell it here.


Most of the good shrimp products come from Asia or Germany...

I have the up dripper, available in two size, 1000ml and 6000ml, the larger one also has a handle.

pretty cheap, small one is USD 4.8 large one is USD 9.95.

 

You are correct that it's not readly available, even in Hong Kong, I've only seen it available in one shop.

  • Thanks 1
Link to comment
Share on other sites

1 hour ago, kms said:

You are correct that it's not readly available, even in Hong Kong, I've only seen it available in one shop.

We should start making our own and selling it.

  • Thanks 1
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Join Our Community!

    Register today, ask questions and share your shrimp and fish tank experiences with us!

  • Must Read SKF Articles

  • Posts

    • sdlTBfanUK
      Thats a great photo, beautiful blue bolt, I hope it survived the molt without dropping the eggs! I think I can just about see some black dots (eyes) on the central egg but can't be 100% sure. I used to (and plan to again) do weekly water change of 10-15% but if you do too large or quick (not drip in new water) that would likely trigger a molt. What KH are they in, my new setup is sitting at (and refusing to budge) KH 3 and PH 7.5 so I may have to settle for neocaridina shrimp this time as opposed to the caridina I want, though not looking/deciding just yet, give the tank a bit more of a run in! Tap water here starts at kH 14, tds 320, when filtered goes to KH 0 and PH 6 but when put in the tank keeps going to KH3 and PH 7.5 despite 3 x 50% water changes???? You may be at 'maximum capacity' with only 20L tank especially if the tank is a cube type rather than shallow type?
    • beanbag
      Right now this tank only has blue bolts and golden bee (red bolts?).  The eggs start off all brown, but at the end, I notice that some are kind of a clear pink-ish color.  So I don't know if that is the egg color of dud or golden bee.  Picture of shrimp only about half hour before molting. The water is always RO + remineralizer, so it should be ok. The tank seems to still be on a "good streak" ever since I started the regimen of weekly water change, monthly gravel vac and plant trim.  The point being to keep the amount of waste low and removing moss / floating plants so that the nitrates go towards growing algae.  At one point, I had three berried females, but only netted about half dozen babies by the end, due to this early molting problem.  There might be about 30-40 shrimp total in 5 gallons, but still very few full-sized adults.
    • ngoomie
      Alright, I've done a bit more research on gentian violet's cancer-causing potential but I haven't yet done research on malachite green's to compare. But from reading the California propositon 65 document about GV (North Americans incl. some Canadians will recognize this as the law that causes some products they buy to be labelled with "known to the state of California to cause cancer", including the exact product I bought) it seems that the risk of cancer is related to internal use, either injection or ingestion. Speaking of ingestion, I think GV bans mainly relate to its use in treating fish/shrimp/etc. which are intended for human consumption, because of the above. And in countries where GV isn't banned for this purpose, it does seem to get used on various species of shrimp without causing any issue for the shrimp themselves (at least enough so for shrimp farming purposes). See the following: In February, the FDA Began Rejecting Imported Shrimp for Gentian Violet and Chloramphenicol (2022 article by Southern Shrimp Alliance) FDA Starts New Calendar Year by Refusing Antibiotic-Contaminated Shrimp from Three BAP-Certified Indian Processors and Adding a BAP-Certified Vietnamese Processor to Import Alert (2024 article by Southern Shrimp Alliance) Southern Shrimp Alliance and some other organizations have tons of other articles in this vein, but I'd be here for a while and would end up writing an absolutely massive post if I were to link every instance I found of articles mentioning shrimp shipments with gentian violet and/or leucogentian violet registering as contaminants. That being said, I know shrimp farmed for consumption and dwarf shrimp are often somewhat distantly related (in fact, the one time a shrimp's species name is listed that I can see, it's the prawn sp. Macrobrachium rosenbergii, who at best occupies the same infraorder as Neocaridina davidi but nothing nearer), but this at least gives a slightly better way of guessing whether it will be safe for aquarium dwarf shrimp or not than my bladder snail anecdote from the OP.
    • sdlTBfanUK
      I would hazard a guess that perhaps those eggs were unfertilized and thereby unviable? Did the eggs change colour, usually yellow to grey as the yolks used up, or any eyes in the eggs. Is your water ok, using RO remineralised and the parameters in range, as I have heard others say that if the water isn't good it can 'force' a molt? How is it going overall, do you have a good size colony in the tank, you may have reached 'maximum occupancy' as a tank can only support so many occupants.
    • beanbag
      Hello folks,  The current problem I am having is that my Taiwan bee shrimp are molting before all their eggs have hatched.  Often the shrimp keep the eggs for 40+ days.  During that time, they lose about half or so, either due to dropping or duds or whatever.  Shortly before molting they look to have about a dozen left, and then they molt with about half a dozen eggs still on the shell.  Then the other shirmp will come and eat the shell.  These last few times, I have been getting around 0-3 surviving babies per batch.  I figure I can make the eggs hatch faster by raising the water temperature more (currently around 68F, which is already a few degrees higher than I used to keep it) or make the shrimp grow slower by feeding them less (protein).  Currently I feed Shrimp King complete every other day, and also a small dab of Shrimp Fit alternating days.  Maybe I can start alternating with more vegetable food like mulberry?  or just decrease the amount of food?
×
×
  • Create New...