Search the Community
Showing results for tags 'divided tank'.
-
I am cycling a 55 gallon (208L) tank. It is divided into 3 sections using Poret foam. There is also a Poret foam corner filter acting as a pre-filter for the canister filter. I haven't seen a tank setup like this so I thought I would share my experiences with all of you :o). Here is the equipment I am using on the tank: 3" thick 30PPI Poret Foam Dividers 2" thick 45PPI Poret Foam Corner Filter CaribSea Flora Max Panted Aquarium substrate (inert) 48" Current Satellite+ Pro Light Aqueon 250W Heater Fluval 306 Canister Filter with Marine Pure media Tunze Osmolator Top Off System Pinpoint pH monitor The tank has been cycling for about 2 and a half weeks. I am using RO water with Shrimpy Daddy products and following the tank cycling procedure on his website. The Ammonia and Nitrite levels were 0 by the end of the second week. If everything continues to go well, I should be able to add shrimp in 2-3 weeks. My current plan is to have a neocaridina and tiger colony in each section. Snowballs with Super Tigers Yellow Cherries with Red Tigers PFRs with OEBTs Here are a few pictures of the tank's progress. This pictures shows the tank after I painted the back. These pics show the equipment being added. I used wire ties to hold the air lines in place. Here is the tank after SD's products were added. This one was taken right after the tank was filled. The corner filter has more than enough room to hide the canister intake, the heater and the pH probe. Added some teddy bear cholla wood. Here it is after I added a few plants. I will add a few more plants this week. I will post a picture afterwards. I would love to hear any comments or suggestions. Thanks.