Jump to content

soda stream co2


HJ V6

Recommended Posts

I just bought a couple of 330gm soda stream gas bottles to start with co2 as I didnt want to buy a big bottle with are around $150sh

so im using the soda stream bottles as they are small and ezy to get and will last about 2-4 months depending on how many BPS it uses

sodastream.jpg

Link to comment
Share on other sites

Awesome stuff dude, make sure you keep us updated on your system & setup! :beer:

Link to comment
Share on other sites

yer sure will im waiting on stuff to come in the mail for it and I got another small tank a couple of days ago for the red cherrys and the guy I got the tanks from gave me like 5 different moss,s and 3 different plants too :D :D

Link to comment
Share on other sites

ok just went to a home brew shop and got a adapter for the soda stream as the thread is different so I can put a reg on it

sodastream1.jpg

sodastream2.jpg

Link to comment
Share on other sites

All ways wanted to do this but didn't know much about it. Thanks for posting this mate. Looking forward for the update.

Link to comment
Share on other sites

All ways wanted to do this but didn't know much about it. Thanks for posting this mate. Looking forward for the update.

hi mate yer ive been looking into this for a mouth or so and theirs not much info around theirs a couple of posts on other forums but they don't give much detail....

Link to comment
Share on other sites

Hi,

I have one of those adapters too, I tried it connect it all last week, but not able to get the regulator screwed on without leaks, leaks seemed to be from the soda stream side rather than the reg adapator, but can't be sure. I'm going to wait for my current soda stream bottle to be nearly used up and then try again so I'm not wasting too much gas. Apparently the release valve button on the top of the gas bottle is at a different depth for every gas bottle, so you need to adjust the middle pin on the adapter to ensure that it is deep enough to depress the release valve. I have to practise the connection, the regulator must be connected before screwing on the soda stream bottle otherwise you will get a massive jet of CO2 wasted straight out.

Also - do this OUTSIDE, so that you don't gas yourself to death. If you get a leak, it's very COLD and burns in seconds. Wear gloves!!!

I'll post again if I have some success, right now it's still "hobby in progress"

Link to comment
Share on other sites

ok thanks mate for the info instrustions it says I might have to adjust it....also do you have the little washer in between the adater and soda stream bottle ??

and for cold burns I used to change gas bottles on fork lifts and got a few not something I want to do again haha

what regulator are you using ?

Link to comment
Share on other sites

ok this is getting scarped as I might be getting a .740gm bottle tomorrow so the 2bottles and adaptor is for sale

Link to comment
Share on other sites

haha yer I was too but im getting a .740gm bottle for free :D ( well swaping something for it )

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Join Our Community!

    Register today, ask questions and share your shrimp and fish tank experiences with us!

  • Must Read SKF Articles

  • Posts

    • sdlTBfanUK
      Thats a great photo, beautiful blue bolt, I hope it survived the molt without dropping the eggs! I think I can just about see some black dots (eyes) on the central egg but can't be 100% sure. I used to (and plan to again) do weekly water change of 10-15% but if you do too large or quick (not drip in new water) that would likely trigger a molt. What KH are they in, my new setup is sitting at (and refusing to budge) KH 3 and PH 7.5 so I may have to settle for neocaridina shrimp this time as opposed to the caridina I want, though not looking/deciding just yet, give the tank a bit more of a run in! Tap water here starts at kH 14, tds 320, when filtered goes to KH 0 and PH 6 but when put in the tank keeps going to KH3 and PH 7.5 despite 3 x 50% water changes???? You may be at 'maximum capacity' with only 20L tank especially if the tank is a cube type rather than shallow type?
    • beanbag
      Right now this tank only has blue bolts and golden bee (red bolts?).  The eggs start off all brown, but at the end, I notice that some are kind of a clear pink-ish color.  So I don't know if that is the egg color of dud or golden bee.  Picture of shrimp only about half hour before molting. The water is always RO + remineralizer, so it should be ok. The tank seems to still be on a "good streak" ever since I started the regimen of weekly water change, monthly gravel vac and plant trim.  The point being to keep the amount of waste low and removing moss / floating plants so that the nitrates go towards growing algae.  At one point, I had three berried females, but only netted about half dozen babies by the end, due to this early molting problem.  There might be about 30-40 shrimp total in 5 gallons, but still very few full-sized adults.
    • ngoomie
      Alright, I've done a bit more research on gentian violet's cancer-causing potential but I haven't yet done research on malachite green's to compare. But from reading the California propositon 65 document about GV (North Americans incl. some Canadians will recognize this as the law that causes some products they buy to be labelled with "known to the state of California to cause cancer", including the exact product I bought) it seems that the risk of cancer is related to internal use, either injection or ingestion. Speaking of ingestion, I think GV bans mainly relate to its use in treating fish/shrimp/etc. which are intended for human consumption, because of the above. And in countries where GV isn't banned for this purpose, it does seem to get used on various species of shrimp without causing any issue for the shrimp themselves (at least enough so for shrimp farming purposes). See the following: In February, the FDA Began Rejecting Imported Shrimp for Gentian Violet and Chloramphenicol (2022 article by Southern Shrimp Alliance) FDA Starts New Calendar Year by Refusing Antibiotic-Contaminated Shrimp from Three BAP-Certified Indian Processors and Adding a BAP-Certified Vietnamese Processor to Import Alert (2024 article by Southern Shrimp Alliance) Southern Shrimp Alliance and some other organizations have tons of other articles in this vein, but I'd be here for a while and would end up writing an absolutely massive post if I were to link every instance I found of articles mentioning shrimp shipments with gentian violet and/or leucogentian violet registering as contaminants. That being said, I know shrimp farmed for consumption and dwarf shrimp are often somewhat distantly related (in fact, the one time a shrimp's species name is listed that I can see, it's the prawn sp. Macrobrachium rosenbergii, who at best occupies the same infraorder as Neocaridina davidi but nothing nearer), but this at least gives a slightly better way of guessing whether it will be safe for aquarium dwarf shrimp or not than my bladder snail anecdote from the OP.
    • sdlTBfanUK
      I would hazard a guess that perhaps those eggs were unfertilized and thereby unviable? Did the eggs change colour, usually yellow to grey as the yolks used up, or any eyes in the eggs. Is your water ok, using RO remineralised and the parameters in range, as I have heard others say that if the water isn't good it can 'force' a molt? How is it going overall, do you have a good size colony in the tank, you may have reached 'maximum occupancy' as a tank can only support so many occupants.
    • beanbag
      Hello folks,  The current problem I am having is that my Taiwan bee shrimp are molting before all their eggs have hatched.  Often the shrimp keep the eggs for 40+ days.  During that time, they lose about half or so, either due to dropping or duds or whatever.  Shortly before molting they look to have about a dozen left, and then they molt with about half a dozen eggs still on the shell.  Then the other shirmp will come and eat the shell.  These last few times, I have been getting around 0-3 surviving babies per batch.  I figure I can make the eggs hatch faster by raising the water temperature more (currently around 68F, which is already a few degrees higher than I used to keep it) or make the shrimp grow slower by feeding them less (protein).  Currently I feed Shrimp King complete every other day, and also a small dab of Shrimp Fit alternating days.  Maybe I can start alternating with more vegetable food like mulberry?  or just decrease the amount of food?
×
×
  • Create New...