Jump to content

Opinions on canister?


Peppy_11

Recommended Posts

Hi guys, getting a new tank in about a months time (EXCITING), so i'm gathering stuff so I can set it up as soon as I get it. Mainly cos im impatient lol. So its a 190L tank, with a mesh & glass divider, and I plan on running one canister and also sponges in each side. I was thinking of getting an eheim 2226 as I have previously owned one and loved it, but was wondering if it is going to be too much or not enough for the tank. It will be hooked up to an inline heater, chiller and maybe uv. The canister that I chose has to have 12/16mm hoses as all my inline gear is that size. When I had this canister on my 55x55cm cube, the flow was too strong so I just drilled out the holes in the spray bar and it slowed the pressure of the water coming out, but didn't affect the amount of filtration which was perfect. Any info/imput would be greatly appreciated as id hate to spend the money and regret it. Thanks in advance

Link to comment
Share on other sites

Ehiems are da bomb, I'm such an Ehiem snob when it comes to canisters, lol. I Have a 2028 & 2224 & they are both working perfectly after 15yrs, I think you will be right with a 2226 but I am a big fan of over filtration so I think you should go the 2228 just for that little bit of extra oomf, you can always drill out the spray bar again & it's definitely better to have too much than not enough. :victorious:

Link to comment
Share on other sites

+1 on eheims... I have the classic 2211, 2215 & 2217. Love em !

+1 on over filtration. Most of my tanks are 8+ time tank volume p/h... One of my 25 lt nano's has a eheim 2211 (300 lt) and Totto Filter (270 lt), that's x23 times ! Shrimps love it ! Bhahahhaha

Link to comment
Share on other sites

A good alternative is instead of having one filter, you have 2... my breeding racks are all setup this way...and I clean the filter out alternatively...so one filter is always maintaning the water balance/bacteria etc ... a bit over the top, but I'll always have this as my insurance....

Link to comment
Share on other sites

As much as id love to run two canisters, my mum is already having a fit that I am setting up another tank and running another chiller. She would throttle me if I set up 2 more canisters lol. And trust me, she will definitely know :/

Link to comment
Share on other sites

Whatever filter you settle for ... just remember that adding a mesh filter or sponge filter to the intake will reduce the flow a bit. So get a filter with more media capacity. Even if it's over powered on paper for your tank size, there are ways to reduce the flow, but you cant increase flow (or can you). As already mentioned, drilling more holes at the spraybar and adding a mesh/sponge prefilter to the intake will reduce flow. The benefit of more media is ... more real estate for beneficial bacteria to colonise.

2x Eheim 2215's cost the same as one 2228.

But 2x 2215s double (approx) the filtration capacity.

You could even swap the 2215 impeller for a 2217 impeller to increase the flow rates of a 2215.

Yes, the impellers from a 2217 will fit a 2215. But since the 2217 impeller has 6 blades as opposed to the 2215's 3 blades (or is it four, can't remember now), it boosts the flow rates of a 2215 canister.

I did this to my 2215. After adding an prefilter, in line heater, CO2 diffuser, flow rates can drop. And I don't even have a chiller. Think of it as a cheap turbo boost for a 2215.

Something to think about.

Link to comment
Share on other sites

I prefer Fluval filters and highly reccomend them, but go with what you have had experience with.

JayC makes a good point about the filter being slowed by the mesh/sponge over the intake. Definitely go bigger than what you think you will need. its much easier to slow a filter down than to try and speed it up.

Link to comment
Share on other sites

The 2217 impeller mod to 2215 is possible the best thing you can do to the 2215.

Also, if they come with media baskets, throw em away and just stack the media yourself. Yes, you might lose the simplicity of just plunging the basket in a bucket of tank water, but you can fit alot more media in there ;)

Go the bigger, if you cannot run 2, why not just go bigger ;) Mum cannot complain then ;)

Link to comment
Share on other sites

I've just brought an Eheim 2215 myself with a 2217 on my 140L 2 footer, they really are great filters, can be a tad noisy but better than most other brands.

Link to comment
Share on other sites

+1 on eheims... I have the classic 2211' date=' 2215 & 2217. Love em !

+1 on over filtration. Most of my tanks are 8+ time tank volume p/h... One of my 25 lt nano's has a eheim 2211 (300 lt) and Totto Filter (270 lt), that's x23 times ! Shrimps love it ! Bhahahhaha[/quote']

BB have you found that the super over filtration has caused the Benibachi soil to lose it's buffering capacity early? The reason I say this is I have a 40l with a 2217 on it and the substrate only 5-6 months old has lost it's buffering..I slowly added fulvic grains (2 packets) that worked for around couple months but then again the ph went 7+?

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Join Our Community!

    Register today, ask questions and share your shrimp and fish tank experiences with us!

  • Must Read SKF Articles

  • Posts

    • sdlTBfanUK
      Thats a great photo, beautiful blue bolt, I hope it survived the molt without dropping the eggs! I think I can just about see some black dots (eyes) on the central egg but can't be 100% sure. I used to (and plan to again) do weekly water change of 10-15% but if you do too large or quick (not drip in new water) that would likely trigger a molt. What KH are they in, my new setup is sitting at (and refusing to budge) KH 3 and PH 7.5 so I may have to settle for neocaridina shrimp this time as opposed to the caridina I want, though not looking/deciding just yet, give the tank a bit more of a run in! Tap water here starts at kH 14, tds 320, when filtered goes to KH 0 and PH 6 but when put in the tank keeps going to KH3 and PH 7.5 despite 3 x 50% water changes???? You may be at 'maximum capacity' with only 20L tank especially if the tank is a cube type rather than shallow type?
    • beanbag
      Right now this tank only has blue bolts and golden bee (red bolts?).  The eggs start off all brown, but at the end, I notice that some are kind of a clear pink-ish color.  So I don't know if that is the egg color of dud or golden bee.  Picture of shrimp only about half hour before molting. The water is always RO + remineralizer, so it should be ok. The tank seems to still be on a "good streak" ever since I started the regimen of weekly water change, monthly gravel vac and plant trim.  The point being to keep the amount of waste low and removing moss / floating plants so that the nitrates go towards growing algae.  At one point, I had three berried females, but only netted about half dozen babies by the end, due to this early molting problem.  There might be about 30-40 shrimp total in 5 gallons, but still very few full-sized adults.
    • ngoomie
      Alright, I've done a bit more research on gentian violet's cancer-causing potential but I haven't yet done research on malachite green's to compare. But from reading the California propositon 65 document about GV (North Americans incl. some Canadians will recognize this as the law that causes some products they buy to be labelled with "known to the state of California to cause cancer", including the exact product I bought) it seems that the risk of cancer is related to internal use, either injection or ingestion. Speaking of ingestion, I think GV bans mainly relate to its use in treating fish/shrimp/etc. which are intended for human consumption, because of the above. And in countries where GV isn't banned for this purpose, it does seem to get used on various species of shrimp without causing any issue for the shrimp themselves (at least enough so for shrimp farming purposes). See the following: In February, the FDA Began Rejecting Imported Shrimp for Gentian Violet and Chloramphenicol (2022 article by Southern Shrimp Alliance) FDA Starts New Calendar Year by Refusing Antibiotic-Contaminated Shrimp from Three BAP-Certified Indian Processors and Adding a BAP-Certified Vietnamese Processor to Import Alert (2024 article by Southern Shrimp Alliance) Southern Shrimp Alliance and some other organizations have tons of other articles in this vein, but I'd be here for a while and would end up writing an absolutely massive post if I were to link every instance I found of articles mentioning shrimp shipments with gentian violet and/or leucogentian violet registering as contaminants. That being said, I know shrimp farmed for consumption and dwarf shrimp are often somewhat distantly related (in fact, the one time a shrimp's species name is listed that I can see, it's the prawn sp. Macrobrachium rosenbergii, who at best occupies the same infraorder as Neocaridina davidi but nothing nearer), but this at least gives a slightly better way of guessing whether it will be safe for aquarium dwarf shrimp or not than my bladder snail anecdote from the OP.
    • sdlTBfanUK
      I would hazard a guess that perhaps those eggs were unfertilized and thereby unviable? Did the eggs change colour, usually yellow to grey as the yolks used up, or any eyes in the eggs. Is your water ok, using RO remineralised and the parameters in range, as I have heard others say that if the water isn't good it can 'force' a molt? How is it going overall, do you have a good size colony in the tank, you may have reached 'maximum occupancy' as a tank can only support so many occupants.
    • beanbag
      Hello folks,  The current problem I am having is that my Taiwan bee shrimp are molting before all their eggs have hatched.  Often the shrimp keep the eggs for 40+ days.  During that time, they lose about half or so, either due to dropping or duds or whatever.  Shortly before molting they look to have about a dozen left, and then they molt with about half a dozen eggs still on the shell.  Then the other shirmp will come and eat the shell.  These last few times, I have been getting around 0-3 surviving babies per batch.  I figure I can make the eggs hatch faster by raising the water temperature more (currently around 68F, which is already a few degrees higher than I used to keep it) or make the shrimp grow slower by feeding them less (protein).  Currently I feed Shrimp King complete every other day, and also a small dab of Shrimp Fit alternating days.  Maybe I can start alternating with more vegetable food like mulberry?  or just decrease the amount of food?
×
×
  • Create New...