Jump to content

Recommended Glass Cleaner


BlueBolts

Recommended Posts

Looking for a quality magnetic glass cleaner...anyone using this, and/or can recommend anther ?

th_db7bf22b28c40a6e2b8150cf7238342a.jpg

Thanks in advance

Link to comment
Share on other sites

Vertex triplex all the way for a large tank or the vertex simplex for nano tanks.

Link to comment
Share on other sites

+1 to the vertex range

i have the duplex and love it

post-3442-139909853486_thumb.jpg

Link to comment
Share on other sites

Have you had enough of the nano mag?

no way....nano mag's is a must have for all my nano tanks :-) searching for a larger unit, preferably with a scraper.

Link to comment
Share on other sites

Anyone has the flipper though ? Wanted to know the quality and whether the "flip" to the scraper works etc...

Link to comment
Share on other sites

Im also after a new glass cleaner, but Nano.

Does the Vertex Simplex have a low profile shape on the internal part?

I want to get right in there without messing stuff up (hardscape is close to glass)

My big cumberson "AquaOne" scraper is, painful and Im noticing scratches, so its going no where near any other tank again...

I dont think I have cleaned glass in, over a year, without pulling the tank down and starting fresh after clado outbreak...

Link to comment
Share on other sites

Boof sounds like you need the two fishes nano mag or similar, I don't have one myself but have seen them around.

Link to comment
Share on other sites

For nano tanks, you can't go past the nanomag.... One of my absolute favourite must have's... Aquotix, our forum sponsor sells them :-)

th_a5e5d7b218ddf9b1d88ef3c4f7bc3202.jpg

Link to comment
Share on other sites

Yeah the two little fishes are awesome, there's also a smaller one than the one in BB's pic, you can even run the super small one down canister hoses, very handy! :victorious:

Link to comment
Share on other sites

Does the internal part of the Nano mag float, if you some how dislodge the magnet?

Link to comment
Share on other sites

No it doesn't. Also, works best on 8mm or less glass thickness. The magnet is strong for e size, and never have a situation. Where it dislodges, as its flexible...

Link to comment
Share on other sites

+1 agree, they use super strong Neo magnets, you can even hold the outside part off the glass a bit & it won't fall away. :victorious:

Link to comment
Share on other sites

Thanks. Might have to get me one of them, so I can manoeuvre it around the tankscape.

It would be the ultimate magnet cleaner if the internal part floated.

Squigs, I don't get it. Do you mean you can attach a neo magnet to the Nano mag cleaner?

I have a dozen neo mags sitting around doing nothing.

Link to comment
Share on other sites

Squigs' date=' I don't get it. Do you mean you can attach a neo magnet to the Nano mag cleaner?

I have a dozen neo mags sitting around doing nothing.[/quote']

You could but what I mean is the mags inside the Nano Mag are Neo's, I've made my own slightly larger scrubber piece from a button Neo mag & some male sticky Velcro, works very well. :victorious:

Link to comment
Share on other sites

I have some plastic one sided razor blades coming?? will see what they are like, I have a scraper that takes these razors, so I am thinking plastic won't scratch but will it clean off Algae?????????

Bob

Link to comment
Share on other sites

  • 2 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Join Our Community!

    Register today, ask questions and share your shrimp and fish tank experiences with us!

  • Must Read SKF Articles

  • Posts

    • sdlTBfanUK
      Thats a great photo, beautiful blue bolt, I hope it survived the molt without dropping the eggs! I think I can just about see some black dots (eyes) on the central egg but can't be 100% sure. I used to (and plan to again) do weekly water change of 10-15% but if you do too large or quick (not drip in new water) that would likely trigger a molt. What KH are they in, my new setup is sitting at (and refusing to budge) KH 3 and PH 7.5 so I may have to settle for neocaridina shrimp this time as opposed to the caridina I want, though not looking/deciding just yet, give the tank a bit more of a run in! Tap water here starts at kH 14, tds 320, when filtered goes to KH 0 and PH 6 but when put in the tank keeps going to KH3 and PH 7.5 despite 3 x 50% water changes???? You may be at 'maximum capacity' with only 20L tank especially if the tank is a cube type rather than shallow type?
    • beanbag
      Right now this tank only has blue bolts and golden bee (red bolts?).  The eggs start off all brown, but at the end, I notice that some are kind of a clear pink-ish color.  So I don't know if that is the egg color of dud or golden bee.  Picture of shrimp only about half hour before molting. The water is always RO + remineralizer, so it should be ok. The tank seems to still be on a "good streak" ever since I started the regimen of weekly water change, monthly gravel vac and plant trim.  The point being to keep the amount of waste low and removing moss / floating plants so that the nitrates go towards growing algae.  At one point, I had three berried females, but only netted about half dozen babies by the end, due to this early molting problem.  There might be about 30-40 shrimp total in 5 gallons, but still very few full-sized adults.
    • ngoomie
      Alright, I've done a bit more research on gentian violet's cancer-causing potential but I haven't yet done research on malachite green's to compare. But from reading the California propositon 65 document about GV (North Americans incl. some Canadians will recognize this as the law that causes some products they buy to be labelled with "known to the state of California to cause cancer", including the exact product I bought) it seems that the risk of cancer is related to internal use, either injection or ingestion. Speaking of ingestion, I think GV bans mainly relate to its use in treating fish/shrimp/etc. which are intended for human consumption, because of the above. And in countries where GV isn't banned for this purpose, it does seem to get used on various species of shrimp without causing any issue for the shrimp themselves (at least enough so for shrimp farming purposes). See the following: In February, the FDA Began Rejecting Imported Shrimp for Gentian Violet and Chloramphenicol (2022 article by Southern Shrimp Alliance) FDA Starts New Calendar Year by Refusing Antibiotic-Contaminated Shrimp from Three BAP-Certified Indian Processors and Adding a BAP-Certified Vietnamese Processor to Import Alert (2024 article by Southern Shrimp Alliance) Southern Shrimp Alliance and some other organizations have tons of other articles in this vein, but I'd be here for a while and would end up writing an absolutely massive post if I were to link every instance I found of articles mentioning shrimp shipments with gentian violet and/or leucogentian violet registering as contaminants. That being said, I know shrimp farmed for consumption and dwarf shrimp are often somewhat distantly related (in fact, the one time a shrimp's species name is listed that I can see, it's the prawn sp. Macrobrachium rosenbergii, who at best occupies the same infraorder as Neocaridina davidi but nothing nearer), but this at least gives a slightly better way of guessing whether it will be safe for aquarium dwarf shrimp or not than my bladder snail anecdote from the OP.
    • sdlTBfanUK
      I would hazard a guess that perhaps those eggs were unfertilized and thereby unviable? Did the eggs change colour, usually yellow to grey as the yolks used up, or any eyes in the eggs. Is your water ok, using RO remineralised and the parameters in range, as I have heard others say that if the water isn't good it can 'force' a molt? How is it going overall, do you have a good size colony in the tank, you may have reached 'maximum occupancy' as a tank can only support so many occupants.
    • beanbag
      Hello folks,  The current problem I am having is that my Taiwan bee shrimp are molting before all their eggs have hatched.  Often the shrimp keep the eggs for 40+ days.  During that time, they lose about half or so, either due to dropping or duds or whatever.  Shortly before molting they look to have about a dozen left, and then they molt with about half a dozen eggs still on the shell.  Then the other shirmp will come and eat the shell.  These last few times, I have been getting around 0-3 surviving babies per batch.  I figure I can make the eggs hatch faster by raising the water temperature more (currently around 68F, which is already a few degrees higher than I used to keep it) or make the shrimp grow slower by feeding them less (protein).  Currently I feed Shrimp King complete every other day, and also a small dab of Shrimp Fit alternating days.  Maybe I can start alternating with more vegetable food like mulberry?  or just decrease the amount of food?
×
×
  • Create New...