Jump to content

High volume airpump - Which one are you using?


KillieOrCory

Recommended Posts

Hi all,

I am looking at getting another air pump for the fishroom. I currently use Aqua One Pond One O2 Plus air pump and an earlier version of the same.

I was thinking of getting LP100. Anybody use/d it. How loud is it and how reliable. I'll have the other two pumps as back ups after getting a new one.

I am going to be running 100+ sponge filters.

Link to comment
Share on other sites

I was thinking of getting LP100. Anybody use/d it. How loud is it and how reliable. .

Resun LP100?

Don't have one myself, but heard good things about it. Quiet. Pumps heaps of air, 150L/min.

But not cheap either. So depends on how much you can get it for.

Other options could include Hailea HAP-120.

If you want more than 150L/min, you'll need to start looking at Air Blowers.

In fact, they are better value for money compared to high volume air pumps.

I suppose if you are going to run 100+ sponge filters, then noise is not going to matter much to you.

Link to comment
Share on other sites

+1 to the v series. I have the v 20 and couldn't be happier.

I have it sitting on some sponge to absorb the vibrations and the bubbles it makes are way louder than the pump.

Link to comment
Share on other sites

I bought an LP100 thinking i could use it for what I had & I could just keep adding tanks without needing to upgrade, boy was I wrong! I got the pump, plugged it in & the thing almost blew me out the garage door, way more than I needed! Needless to say I was well impressed with the power & lack of sound compared to others with the same volume. I'm now using an LP40 for 20 tanks, but I'm just about to upgrade to an LP60 & that will be running 30+ tanks. If you set the system up right you'll be well impressed with the all over performance. I'm spewing you didn't mention it earlier as I only just got sold my LP100 for $100 & I had only plugged it in for about 20seconds. You won't be disappointed with it dude! :victorious:

Link to comment
Share on other sites

+1 to the v series. I have the v 20 and couldn't be happier.

I have it sitting on some sponge to absorb the vibrations and the bubbles it makes are way louder than the pump.

Just a tip dude, if you can hear the bubbles coming out of the sponge filters then you probably have too much air going through them. :victorious:

Link to comment
Share on other sites

Just a tip dude' date=' if you can hear the bubbles coming out of the sponge filters then you probably have too much air going through them. :victorious:[/quote']

Nah its all the excess air going to my pair of k1 setups in the sump making the noise.

Even so, bubbles still make noise and the pump is still quieter than them.

Link to comment
Share on other sites

Nah its all the excess air going to my pair of k1 setups in the sump making the noise.

Even so' date=' bubbles still make noise and the pump is still quieter than them.[/quote']

I have not heard a pump as quiet as the Hailea v series

i have owned a jebo p55 and the lp resun series

aswell as alot of others

v series are the way to go TRUST ME

Link to comment
Share on other sites

I have not heard a pump as quiet as the Hailea v series

i have owned a jebo p55 and the lp resun series

aswell as alot of others

v series are the way to go TRUST ME

Didn't I recommend you get the V series in the first place?

Link to comment
Share on other sites

Hey Serkan, Have you checked out the air pump that Paul Hailes sells? He is using one in his garage setup and it seems to do a pretty good job.

Link to comment
Share on other sites

I only managed to find Hailea V60 do they come larger volume? There is a Hailea HAP100 that does 100L per min.

Link to comment
Share on other sites

I only managed to find Hailea V60 do they come larger volume? There is a Hailea HAP100 that does 100L per min.

There is a HAP 120, which I posted earlier. $173.

45db noise, so not too bad.

Link to comment
Share on other sites

Go a blower after using diaphragm and piston pumps over the years have found nothing compares to a blower cheap to run large output of air and less chance of problems only problem a bit noisier.Have run over 200 filters combo of box and sponge on 180w.Most breeders I know use them for these reasons.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Join Our Community!

    Register today, ask questions and share your shrimp and fish tank experiences with us!

  • Must Read SKF Articles

  • Posts

    • sdlTBfanUK
      Thats a great photo, beautiful blue bolt, I hope it survived the molt without dropping the eggs! I think I can just about see some black dots (eyes) on the central egg but can't be 100% sure. I used to (and plan to again) do weekly water change of 10-15% but if you do too large or quick (not drip in new water) that would likely trigger a molt. What KH are they in, my new setup is sitting at (and refusing to budge) KH 3 and PH 7.5 so I may have to settle for neocaridina shrimp this time as opposed to the caridina I want, though not looking/deciding just yet, give the tank a bit more of a run in! Tap water here starts at kH 14, tds 320, when filtered goes to KH 0 and PH 6 but when put in the tank keeps going to KH3 and PH 7.5 despite 3 x 50% water changes???? You may be at 'maximum capacity' with only 20L tank especially if the tank is a cube type rather than shallow type?
    • beanbag
      Right now this tank only has blue bolts and golden bee (red bolts?).  The eggs start off all brown, but at the end, I notice that some are kind of a clear pink-ish color.  So I don't know if that is the egg color of dud or golden bee.  Picture of shrimp only about half hour before molting. The water is always RO + remineralizer, so it should be ok. The tank seems to still be on a "good streak" ever since I started the regimen of weekly water change, monthly gravel vac and plant trim.  The point being to keep the amount of waste low and removing moss / floating plants so that the nitrates go towards growing algae.  At one point, I had three berried females, but only netted about half dozen babies by the end, due to this early molting problem.  There might be about 30-40 shrimp total in 5 gallons, but still very few full-sized adults.
    • ngoomie
      Alright, I've done a bit more research on gentian violet's cancer-causing potential but I haven't yet done research on malachite green's to compare. But from reading the California propositon 65 document about GV (North Americans incl. some Canadians will recognize this as the law that causes some products they buy to be labelled with "known to the state of California to cause cancer", including the exact product I bought) it seems that the risk of cancer is related to internal use, either injection or ingestion. Speaking of ingestion, I think GV bans mainly relate to its use in treating fish/shrimp/etc. which are intended for human consumption, because of the above. And in countries where GV isn't banned for this purpose, it does seem to get used on various species of shrimp without causing any issue for the shrimp themselves (at least enough so for shrimp farming purposes). See the following: In February, the FDA Began Rejecting Imported Shrimp for Gentian Violet and Chloramphenicol (2022 article by Southern Shrimp Alliance) FDA Starts New Calendar Year by Refusing Antibiotic-Contaminated Shrimp from Three BAP-Certified Indian Processors and Adding a BAP-Certified Vietnamese Processor to Import Alert (2024 article by Southern Shrimp Alliance) Southern Shrimp Alliance and some other organizations have tons of other articles in this vein, but I'd be here for a while and would end up writing an absolutely massive post if I were to link every instance I found of articles mentioning shrimp shipments with gentian violet and/or leucogentian violet registering as contaminants. That being said, I know shrimp farmed for consumption and dwarf shrimp are often somewhat distantly related (in fact, the one time a shrimp's species name is listed that I can see, it's the prawn sp. Macrobrachium rosenbergii, who at best occupies the same infraorder as Neocaridina davidi but nothing nearer), but this at least gives a slightly better way of guessing whether it will be safe for aquarium dwarf shrimp or not than my bladder snail anecdote from the OP.
    • sdlTBfanUK
      I would hazard a guess that perhaps those eggs were unfertilized and thereby unviable? Did the eggs change colour, usually yellow to grey as the yolks used up, or any eyes in the eggs. Is your water ok, using RO remineralised and the parameters in range, as I have heard others say that if the water isn't good it can 'force' a molt? How is it going overall, do you have a good size colony in the tank, you may have reached 'maximum occupancy' as a tank can only support so many occupants.
    • beanbag
      Hello folks,  The current problem I am having is that my Taiwan bee shrimp are molting before all their eggs have hatched.  Often the shrimp keep the eggs for 40+ days.  During that time, they lose about half or so, either due to dropping or duds or whatever.  Shortly before molting they look to have about a dozen left, and then they molt with about half a dozen eggs still on the shell.  Then the other shirmp will come and eat the shell.  These last few times, I have been getting around 0-3 surviving babies per batch.  I figure I can make the eggs hatch faster by raising the water temperature more (currently around 68F, which is already a few degrees higher than I used to keep it) or make the shrimp grow slower by feeding them less (protein).  Currently I feed Shrimp King complete every other day, and also a small dab of Shrimp Fit alternating days.  Maybe I can start alternating with more vegetable food like mulberry?  or just decrease the amount of food?
×
×
  • Create New...