Jump to content

Is there a better RO unit out there?


shrimpy1547

Recommended Posts

I have one of the JBL Ro unit, it produces approx. 10L in about 2 - 2.5 hours...

is this normal?

I've seen other units that produces water much faster.

Also what do you guys do with the wasted water? do you reuse?

Link to comment
Share on other sites

It all depends on how much you want to spend & how much the unit is rated for, my unit does about 10L per hour & the more expensive ones will do a lot more than that. :victorious:

I put the waste on the garden, plants have never looked better :encouragement:

Link to comment
Share on other sites

Check Filter Systems Australia they have some great RO units and are more then willing to help to accommodate to your needs...It depends on the GPD or LPD of the unit, you can get them for pretty cheap these days...with the waste I use it to water the plants, mop the floor, flush my outside toilet, etc....

Maybe ask them for a membrane that will allow more LPD (litres per day) and change that out from your existing unit.

Link to comment
Share on other sites

+1 on Filter System Australia. Have used their system, and they've been extremely helpful with information/advise, plus they sponsored a comp here.

My RO unit is a small portable system, does approx 20 lt in 2.5 hours, but I don't mind, just plan/schedule for this period....

Link to comment
Share on other sites

Put the excess water in the washing machine!

Saves so much water!

Mine does 10l hour too :D

Btw anyone know which part of the filter i replace if my tds from the water has gone from 0 to about 13

Still very clean water but yeh dunno if I should continue to let it rise

Link to comment
Share on other sites

it's the DI resin I believe.

I think they sell the resin and you replace the old stuff keeping the same canister thingy. I'm not sure of the actual process but someone here might know.

Link to comment
Share on other sites

Yeah it is the DI(DeIonization) resin which needs replacing. Just unscrew the end & rinse out the old stuff, wash the new stuff & whack it in, simples! :victorious:

Link to comment
Share on other sites

I just went through this process with my 4 stage RO/DI filter. Once a year (or when your TDS starts to climb) you should be changing the sediment trap + Carbon filter + DI resin. Every second year you replace the RO membrane plus all of the rest.

Link to comment
Share on other sites

+1 on Filter System Australia. Have used their system' date=' and they've been extremely helpful with information/advise, plus they sponsored a comp here.

My RO unit is a small portable system, does approx 20 lt in 2.5 hours, but I don't mind, just plan/schedule for this period....[/quote']

care to share which one you got BB?

Link to comment
Share on other sites

  • 4 months later...
care to share which one you got BB?

I'm not sure which one BB's got but I know transportable r/o unit as well.

http://www.ebay.com.au/itm/PORTABLE-REVERSE-OSMOSIS-WATER-FILTER-KIT-FILTERS-OUT-FLUORIDE-1-70-/251396176140?pt=AU_SmallKitchenAppliances&hash=item3a8861390c&_uhb=1

Check it out.

I'm planning to get one very soon.

Just have inquired the guy if they would be able to change 50 gpd r/o unit to 100gpd r/o unit and the answer was yes.

However they warned me that the amount of waster water will be x4 compared to 50 gpd to get same amount of pure water.

So I decided to stick with the original set.

Wasting 400L to get 100L is just too much to me and to this planet :stupid:

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Join Our Community!

    Register today, ask questions and share your shrimp and fish tank experiences with us!

  • Must Read SKF Articles

  • Posts

    • sdlTBfanUK
      Thats a great photo, beautiful blue bolt, I hope it survived the molt without dropping the eggs! I think I can just about see some black dots (eyes) on the central egg but can't be 100% sure. I used to (and plan to again) do weekly water change of 10-15% but if you do too large or quick (not drip in new water) that would likely trigger a molt. What KH are they in, my new setup is sitting at (and refusing to budge) KH 3 and PH 7.5 so I may have to settle for neocaridina shrimp this time as opposed to the caridina I want, though not looking/deciding just yet, give the tank a bit more of a run in! Tap water here starts at kH 14, tds 320, when filtered goes to KH 0 and PH 6 but when put in the tank keeps going to KH3 and PH 7.5 despite 3 x 50% water changes???? You may be at 'maximum capacity' with only 20L tank especially if the tank is a cube type rather than shallow type?
    • beanbag
      Right now this tank only has blue bolts and golden bee (red bolts?).  The eggs start off all brown, but at the end, I notice that some are kind of a clear pink-ish color.  So I don't know if that is the egg color of dud or golden bee.  Picture of shrimp only about half hour before molting. The water is always RO + remineralizer, so it should be ok. The tank seems to still be on a "good streak" ever since I started the regimen of weekly water change, monthly gravel vac and plant trim.  The point being to keep the amount of waste low and removing moss / floating plants so that the nitrates go towards growing algae.  At one point, I had three berried females, but only netted about half dozen babies by the end, due to this early molting problem.  There might be about 30-40 shrimp total in 5 gallons, but still very few full-sized adults.
    • ngoomie
      Alright, I've done a bit more research on gentian violet's cancer-causing potential but I haven't yet done research on malachite green's to compare. But from reading the California propositon 65 document about GV (North Americans incl. some Canadians will recognize this as the law that causes some products they buy to be labelled with "known to the state of California to cause cancer", including the exact product I bought) it seems that the risk of cancer is related to internal use, either injection or ingestion. Speaking of ingestion, I think GV bans mainly relate to its use in treating fish/shrimp/etc. which are intended for human consumption, because of the above. And in countries where GV isn't banned for this purpose, it does seem to get used on various species of shrimp without causing any issue for the shrimp themselves (at least enough so for shrimp farming purposes). See the following: In February, the FDA Began Rejecting Imported Shrimp for Gentian Violet and Chloramphenicol (2022 article by Southern Shrimp Alliance) FDA Starts New Calendar Year by Refusing Antibiotic-Contaminated Shrimp from Three BAP-Certified Indian Processors and Adding a BAP-Certified Vietnamese Processor to Import Alert (2024 article by Southern Shrimp Alliance) Southern Shrimp Alliance and some other organizations have tons of other articles in this vein, but I'd be here for a while and would end up writing an absolutely massive post if I were to link every instance I found of articles mentioning shrimp shipments with gentian violet and/or leucogentian violet registering as contaminants. That being said, I know shrimp farmed for consumption and dwarf shrimp are often somewhat distantly related (in fact, the one time a shrimp's species name is listed that I can see, it's the prawn sp. Macrobrachium rosenbergii, who at best occupies the same infraorder as Neocaridina davidi but nothing nearer), but this at least gives a slightly better way of guessing whether it will be safe for aquarium dwarf shrimp or not than my bladder snail anecdote from the OP.
    • sdlTBfanUK
      I would hazard a guess that perhaps those eggs were unfertilized and thereby unviable? Did the eggs change colour, usually yellow to grey as the yolks used up, or any eyes in the eggs. Is your water ok, using RO remineralised and the parameters in range, as I have heard others say that if the water isn't good it can 'force' a molt? How is it going overall, do you have a good size colony in the tank, you may have reached 'maximum occupancy' as a tank can only support so many occupants.
    • beanbag
      Hello folks,  The current problem I am having is that my Taiwan bee shrimp are molting before all their eggs have hatched.  Often the shrimp keep the eggs for 40+ days.  During that time, they lose about half or so, either due to dropping or duds or whatever.  Shortly before molting they look to have about a dozen left, and then they molt with about half a dozen eggs still on the shell.  Then the other shirmp will come and eat the shell.  These last few times, I have been getting around 0-3 surviving babies per batch.  I figure I can make the eggs hatch faster by raising the water temperature more (currently around 68F, which is already a few degrees higher than I used to keep it) or make the shrimp grow slower by feeding them less (protein).  Currently I feed Shrimp King complete every other day, and also a small dab of Shrimp Fit alternating days.  Maybe I can start alternating with more vegetable food like mulberry?  or just decrease the amount of food?
×
×
  • Create New...