Jump to content

My auto water change system


Squiggle

Recommended Posts

Hey All, I was asked to do an explanation of my auto water change system :encouragement:

First of all I plumbed a tap in to the inlet side between the pump & the tanks

image_zps1fac295d.jpg

I ran the hose from the tap to a 3x1.5x1.5 & the tap is set to drip 4L per day which works out at about 5% a fortnight

image_zps75b41918.jpg

This is the hose hanging in to the tank

image_zpsfd944b6e.jpg

This is the float level unit it tops the water back up from a 100L storage tank

image_zps1ce1bb7e.jpg

This is the storage tank, I fill it with mineralized RO water, it has a tap on the front to a 13mm hose then it goes to an adapter to convert it to the white hose for the float unit. The hose on the front of the tank is a float level for the storage tank so I know how much water is left

image_zps0107525d.jpg

image_zps4cdb665e.jpg

Hope this helps anyone wanting to do an auto water change system :victorious:

Link to comment
Share on other sites

Thanks Squiggle. Very nice :encouragement: Will keep this in mind when i do proper racking (one day)...

Link to comment
Share on other sites

Hi Jay,

That will make your life easier, good move!!!

Where did you get the small float valve and do you know how much pressure it can cope with? I ask because if I use one it will be on mains pressure, I can always use a pressure reducing valve.

Bob

Link to comment
Share on other sites

Thanks guys, definitely have to give Dean credit for explaining it to me :victorious:

@Bob, I got it from an online store :encouragement: I'm not sure if it would take mains pressure, I wouldn't risk it though, they are designed for use with RO units :victorious:

Link to comment
Share on other sites

I have this system in my rack ATM and there's no need for heavy water change. I just have to feed the shrimps everyday and that's it. Except for filling the storage tank once a month but I just get the small tube from the the RO unit and put it in my storage tank. It takes about half a day to fill my storage tank. Makes life much easier, no heavy lifting.

Link to comment
Share on other sites

Thanks Mr Squig, I will look into it and a pressure reducer is the go then. I usually use a cattle trough valve but they take up a lot of space even if you bend them.

Bob

Link to comment
Share on other sites

  • 3 weeks later...
  • 6 months later...

Hahaha, don't worry dude, it looks way more complicated than it is. When you need to set it up give me a yo & I'll sort you out. :encouragement:

Link to comment
Share on other sites

how well has the valve lasted? can you please pm me the website you got it from. i really need to sort out my ro unit to auto shut off when my drum is full

Link to comment
Share on other sites

Squigs,

could you get a better (close up) pic of the water tank's tap?

I like how you've used the hose as a water level indicator.

Link to comment
Share on other sites

No prob dude I'll do it tonight but I haven't used the tap, I put a bulk head in the tank above the tap, an elbow off it & the clear hose comes off that for the water level. :encouragement:

Link to comment
Share on other sites

hi squiggs

wonder what is best to drain out the water to the bathroom? im thinking to using long hose and use gravity. but not sure will work to pump out the water out of the tank. i have 200 L fish tank, its been a while lifting the bucket do water changes. what i need is easier way to drain the water out without doing lifting and sucking out air through mouth :D

Link to comment
Share on other sites

Syphoning with a long hose is the easiest way to do that, I also like using a pump connected to a long hose for the same job, does it a lot quicker! :encouragement:

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Join Our Community!

    Register today, ask questions and share your shrimp and fish tank experiences with us!

  • Must Read SKF Articles

  • Posts

    • sdlTBfanUK
      Thats a great photo, beautiful blue bolt, I hope it survived the molt without dropping the eggs! I think I can just about see some black dots (eyes) on the central egg but can't be 100% sure. I used to (and plan to again) do weekly water change of 10-15% but if you do too large or quick (not drip in new water) that would likely trigger a molt. What KH are they in, my new setup is sitting at (and refusing to budge) KH 3 and PH 7.5 so I may have to settle for neocaridina shrimp this time as opposed to the caridina I want, though not looking/deciding just yet, give the tank a bit more of a run in! Tap water here starts at kH 14, tds 320, when filtered goes to KH 0 and PH 6 but when put in the tank keeps going to KH3 and PH 7.5 despite 3 x 50% water changes???? You may be at 'maximum capacity' with only 20L tank especially if the tank is a cube type rather than shallow type?
    • beanbag
      Right now this tank only has blue bolts and golden bee (red bolts?).  The eggs start off all brown, but at the end, I notice that some are kind of a clear pink-ish color.  So I don't know if that is the egg color of dud or golden bee.  Picture of shrimp only about half hour before molting. The water is always RO + remineralizer, so it should be ok. The tank seems to still be on a "good streak" ever since I started the regimen of weekly water change, monthly gravel vac and plant trim.  The point being to keep the amount of waste low and removing moss / floating plants so that the nitrates go towards growing algae.  At one point, I had three berried females, but only netted about half dozen babies by the end, due to this early molting problem.  There might be about 30-40 shrimp total in 5 gallons, but still very few full-sized adults.
    • ngoomie
      Alright, I've done a bit more research on gentian violet's cancer-causing potential but I haven't yet done research on malachite green's to compare. But from reading the California propositon 65 document about GV (North Americans incl. some Canadians will recognize this as the law that causes some products they buy to be labelled with "known to the state of California to cause cancer", including the exact product I bought) it seems that the risk of cancer is related to internal use, either injection or ingestion. Speaking of ingestion, I think GV bans mainly relate to its use in treating fish/shrimp/etc. which are intended for human consumption, because of the above. And in countries where GV isn't banned for this purpose, it does seem to get used on various species of shrimp without causing any issue for the shrimp themselves (at least enough so for shrimp farming purposes). See the following: In February, the FDA Began Rejecting Imported Shrimp for Gentian Violet and Chloramphenicol (2022 article by Southern Shrimp Alliance) FDA Starts New Calendar Year by Refusing Antibiotic-Contaminated Shrimp from Three BAP-Certified Indian Processors and Adding a BAP-Certified Vietnamese Processor to Import Alert (2024 article by Southern Shrimp Alliance) Southern Shrimp Alliance and some other organizations have tons of other articles in this vein, but I'd be here for a while and would end up writing an absolutely massive post if I were to link every instance I found of articles mentioning shrimp shipments with gentian violet and/or leucogentian violet registering as contaminants. That being said, I know shrimp farmed for consumption and dwarf shrimp are often somewhat distantly related (in fact, the one time a shrimp's species name is listed that I can see, it's the prawn sp. Macrobrachium rosenbergii, who at best occupies the same infraorder as Neocaridina davidi but nothing nearer), but this at least gives a slightly better way of guessing whether it will be safe for aquarium dwarf shrimp or not than my bladder snail anecdote from the OP.
    • sdlTBfanUK
      I would hazard a guess that perhaps those eggs were unfertilized and thereby unviable? Did the eggs change colour, usually yellow to grey as the yolks used up, or any eyes in the eggs. Is your water ok, using RO remineralised and the parameters in range, as I have heard others say that if the water isn't good it can 'force' a molt? How is it going overall, do you have a good size colony in the tank, you may have reached 'maximum occupancy' as a tank can only support so many occupants.
    • beanbag
      Hello folks,  The current problem I am having is that my Taiwan bee shrimp are molting before all their eggs have hatched.  Often the shrimp keep the eggs for 40+ days.  During that time, they lose about half or so, either due to dropping or duds or whatever.  Shortly before molting they look to have about a dozen left, and then they molt with about half a dozen eggs still on the shell.  Then the other shirmp will come and eat the shell.  These last few times, I have been getting around 0-3 surviving babies per batch.  I figure I can make the eggs hatch faster by raising the water temperature more (currently around 68F, which is already a few degrees higher than I used to keep it) or make the shrimp grow slower by feeding them less (protein).  Currently I feed Shrimp King complete every other day, and also a small dab of Shrimp Fit alternating days.  Maybe I can start alternating with more vegetable food like mulberry?  or just decrease the amount of food?
×
×
  • Create New...