Jump to content

Tying Moss to Tiles/Slates...


Dean

Recommended Posts

This is just a quick how to on tying moss to tiles.

Need

Tiles/Slate.

Cotton String.

Moss.

first get your self some tiles or slate of a size that you are happy with.

i used a 5x5 porcelain tile for this example.

lay the tiles out in preparation for moss.

post-24-139909856769_thumb.jpg

then add a covering of moss that you want to grow. I used Mini riccia for this example.

post-24-139909856772_thumb.jpg

now depending on what moss you are tying on you need to adjust how close your threads are tied together.

as Mini Riccia is very fine, i tied it very close together.

[ATTACH=CONFIG]251[/ATTACH]

and this is an example of how close i tied the other moss

Singapore moss

[ATTACH=CONFIG]252[/ATTACH]

US Fissiddens

[ATTACH=CONFIG]253[/ATTACH]

and after a few hours of tying and a few rolls of cotton this is what you get :)

post-12-139909856776_thumb.jpg

post-29-139909856697_thumb.jpg

post-29-139909856699_thumb.jpg

post-29-139909856701_thumb.jpg

post-29-139909856704_thumb.jpg

post-29-139909856706_thumb.jpg

post-29-13990985671_thumb.jpg

Link to comment
Share on other sites

wow nice Dean, thats alot of moss. did you count how many tiles there are?

Link to comment
Share on other sites

thanks for the sticky Benny, lol i was going to do that later myself :) but you beat me!

@lachie, yes its an old photo and the that tank is now full with 350 tiles/moss

i still have 3 more tanks that size to fill when i get the time :)

Link to comment
Share on other sites

@ HeavyD lol, the cherry shrimp in that tank are very happy, i keep trying to get them all out but cant catch them all.

@ Loach, i might sell a few but moss takes so long to grow and every time they start to look good i use them in a tank :)

i will eventually run out of tank space for them and need to sell them so it will happen eventually .

Link to comment
Share on other sites

@ HeavyD lol' date=' the cherry shrimp in that tank are very happy, i keep trying to get them all out but cant catch them all.

@ Loach, i might sell a few but moss takes so long to grow and every time they start to look good i use them in a tank :)

i will eventually run out of tank space for them and need to sell them so it will happen eventually .[/quote']

Dean, I mean the raw tiles :)

I dont have access to a tile cutter nor am i a tiler! The moss, with these great instructions i can do myself ;)

Link to comment
Share on other sites

ok, here is a little secret that everyone can use!!!

Step 1. go to your local tile shop

Step 2. ask for some 50x50 (5x5) mosaic tiles on sheets as a sample because your tiling your pool/ house/ what ever.

or say your boss sent you down to see if they had any leftovers of the above that you could use to do some repairs etc.

if its left over stock or old/ discontinued stock they will either give it to you for free or super cheep.

just make your story convincing :) and remember there are lots of tile shops in most areas so visit a few :)

Step 3. if they are on mesh backings, just soak them in a bucket for 24 hrs and give them a scrub to get any mesh glue or

contaminants off them and your good to go.

Link to comment
Share on other sites

mr dean can you please shows ur more pics of the moss and what they look like when they are more grown? amazing btw :)

Link to comment
Share on other sites

What kind of tile would be best? Glazed or unglazed?

Not sure if moss woud attach to a glazed tile. I have also heard slate tiles work well.

Link to comment
Share on other sites

@ yowie, no prob mate. thought it was a better answer than just writing yes or no on your thread :)

@gbang, no prob as soon as i get a little time i will.

@Brenkirk, un-glazed for sure, the more rough the surface the better grip the moss gets and you can then remove the cotton and it looks nice and clean.

@loach, your on the money, and slate works very well indeed. just myself i found it easier to use tiles as i didnt need to cut them :)

Link to comment
Share on other sites

Great DIY guide! And you have a very impressive moss growing setup!!! I would love to see a pic of all the tanks to get an idea of the scale of operations!! :P

Link to comment
Share on other sites

  • 1 month later...
  • 5 months later...

Mite be a silly question but how do u no wen to take the cotton of .cheers who ever answers

Link to comment
Share on other sites

Mite be a silly question but how do u no wen to take the cotton of .cheers who ever answers

There's no such thing as a silly question..... You just leave the string on, and the moss will just grow over it, and completely hide it.

Link to comment
Share on other sites

Nice write-up dean! I have not thought to use an unglazed tile before! it will defiantly give that a go

For those interested, Here is a video I made last month on another method using slate and mesh

http://www.youtube.com/watch?v=5Igf9efoWLU

Link to comment
Share on other sites

Thanks for the video Aquathumb....Your technique & demonstration certainly make DIY moss slate look like fun & easy...Cheers

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Join Our Community!

    Register today, ask questions and share your shrimp and fish tank experiences with us!

  • Must Read SKF Articles

  • Posts

    • sdlTBfanUK
      Thats a great photo, beautiful blue bolt, I hope it survived the molt without dropping the eggs! I think I can just about see some black dots (eyes) on the central egg but can't be 100% sure. I used to (and plan to again) do weekly water change of 10-15% but if you do too large or quick (not drip in new water) that would likely trigger a molt. What KH are they in, my new setup is sitting at (and refusing to budge) KH 3 and PH 7.5 so I may have to settle for neocaridina shrimp this time as opposed to the caridina I want, though not looking/deciding just yet, give the tank a bit more of a run in! Tap water here starts at kH 14, tds 320, when filtered goes to KH 0 and PH 6 but when put in the tank keeps going to KH3 and PH 7.5 despite 3 x 50% water changes???? You may be at 'maximum capacity' with only 20L tank especially if the tank is a cube type rather than shallow type?
    • beanbag
      Right now this tank only has blue bolts and golden bee (red bolts?).  The eggs start off all brown, but at the end, I notice that some are kind of a clear pink-ish color.  So I don't know if that is the egg color of dud or golden bee.  Picture of shrimp only about half hour before molting. The water is always RO + remineralizer, so it should be ok. The tank seems to still be on a "good streak" ever since I started the regimen of weekly water change, monthly gravel vac and plant trim.  The point being to keep the amount of waste low and removing moss / floating plants so that the nitrates go towards growing algae.  At one point, I had three berried females, but only netted about half dozen babies by the end, due to this early molting problem.  There might be about 30-40 shrimp total in 5 gallons, but still very few full-sized adults.
    • ngoomie
      Alright, I've done a bit more research on gentian violet's cancer-causing potential but I haven't yet done research on malachite green's to compare. But from reading the California propositon 65 document about GV (North Americans incl. some Canadians will recognize this as the law that causes some products they buy to be labelled with "known to the state of California to cause cancer", including the exact product I bought) it seems that the risk of cancer is related to internal use, either injection or ingestion. Speaking of ingestion, I think GV bans mainly relate to its use in treating fish/shrimp/etc. which are intended for human consumption, because of the above. And in countries where GV isn't banned for this purpose, it does seem to get used on various species of shrimp without causing any issue for the shrimp themselves (at least enough so for shrimp farming purposes). See the following: In February, the FDA Began Rejecting Imported Shrimp for Gentian Violet and Chloramphenicol (2022 article by Southern Shrimp Alliance) FDA Starts New Calendar Year by Refusing Antibiotic-Contaminated Shrimp from Three BAP-Certified Indian Processors and Adding a BAP-Certified Vietnamese Processor to Import Alert (2024 article by Southern Shrimp Alliance) Southern Shrimp Alliance and some other organizations have tons of other articles in this vein, but I'd be here for a while and would end up writing an absolutely massive post if I were to link every instance I found of articles mentioning shrimp shipments with gentian violet and/or leucogentian violet registering as contaminants. That being said, I know shrimp farmed for consumption and dwarf shrimp are often somewhat distantly related (in fact, the one time a shrimp's species name is listed that I can see, it's the prawn sp. Macrobrachium rosenbergii, who at best occupies the same infraorder as Neocaridina davidi but nothing nearer), but this at least gives a slightly better way of guessing whether it will be safe for aquarium dwarf shrimp or not than my bladder snail anecdote from the OP.
    • sdlTBfanUK
      I would hazard a guess that perhaps those eggs were unfertilized and thereby unviable? Did the eggs change colour, usually yellow to grey as the yolks used up, or any eyes in the eggs. Is your water ok, using RO remineralised and the parameters in range, as I have heard others say that if the water isn't good it can 'force' a molt? How is it going overall, do you have a good size colony in the tank, you may have reached 'maximum occupancy' as a tank can only support so many occupants.
    • beanbag
      Hello folks,  The current problem I am having is that my Taiwan bee shrimp are molting before all their eggs have hatched.  Often the shrimp keep the eggs for 40+ days.  During that time, they lose about half or so, either due to dropping or duds or whatever.  Shortly before molting they look to have about a dozen left, and then they molt with about half a dozen eggs still on the shell.  Then the other shirmp will come and eat the shell.  These last few times, I have been getting around 0-3 surviving babies per batch.  I figure I can make the eggs hatch faster by raising the water temperature more (currently around 68F, which is already a few degrees higher than I used to keep it) or make the shrimp grow slower by feeding them less (protein).  Currently I feed Shrimp King complete every other day, and also a small dab of Shrimp Fit alternating days.  Maybe I can start alternating with more vegetable food like mulberry?  or just decrease the amount of food?
×
×
  • Create New...