Jump to content

First Attempt at Planted Tank Setup


newbreed

Recommended Posts

So I was lucky enough o have a few days off last week and had made a decision to attempt a planted tank setup.

 

I had a beautiful 24x18x18 tank setup that I won in a raffle in 2013 going to waste as a BBA Jungle. It needed a makeover!!!

 

post-558-0-21700800-1421143484_thumb.jpg

 

I had a half hearted attempt with plants a year or so back so managed to dig out an old basic CO2 system. In my usual impulsive way, when I bought it I bought two spare refills, which have finally come in handy!!

 

post-558-0-00323900-1421143531_thumb.jpg

post-558-0-79851300-1421143557_thumb.jpg

 

And I had, for the first time in my life really, planned ahead. The following plants were delivered on the planting day!!

 

post-558-0-57946900-1421143506_thumb.jpg

  • Like 1
Link to comment
Share on other sites

I had also ordered some ADA Amazona Powder soil and some ADA Power Sand to get things started off well! Thanks Tech Den! Superfast delivery made it the day before planting day!!

 

I had picked up a bargain on my travels of some volcanic soil. Due to the grain size in the powder substrate, I checked with some plant people and, following their advice, decided to use some bags of this volcanic soil (I used Black) under the powder to get better water flow to the plant roots.

 

post-558-0-75633700-1421144243_thumb.jpg

 

I had picked up some coreflute a month ago and had placed this behind the tank to give it a solid backdrop.

 

So I started to set it up and couldn't see what I was doing due to the cloudiness in the water!!

 

I was out there first thing second day, determined to get it laid out. This is what I saw as I went off to work the second day!

 

post-558-0-20397900-1421144255_thumb.jpg

 

post-558-0-93821300-1421144267_thumb.jpg

 

post-558-0-49302100-1421144279_thumb.jpg

 

And this is how different it looked last thing that night!!

 

post-558-0-43025800-1421144292_thumb.jpg

 

Funny to think it, but I was stoked!!!

 

Link to comment
Share on other sites

I had recently bought an Up Aqua Pro Z Led light which will now be used to it's potential. (Though considering the new Kessil now!!)

 

I had the eheim 2213 that had been running on the tank previously hooked up to another tank to keep it running. I connected it all back up.

 

I have some lily pipes on order, due later this week. To try and make it look the part.

 

So after three days this is how it has come up....

 

post-558-0-96444100-1421144595_thumb.jpg

 

Top View

 

post-558-0-08223700-1421144618_thumb.jpg

 

I know it's just stems and not a scape, but I am really pleased with it!

 

Once it has been running for a month and I get a good handle on its water parameters, I might decide to add some shrimp.

 

Depending on algae growth, the ottos may have to move in first!!!

 

Though I am only running the CO2 unit for four hours a day. Probably not ideal but has to be better than nothing I think!!

 

What do you think, not bad for a newbie???

  • Like 3
Link to comment
Share on other sites

How do you find the Co2 kits? Are they alright? What plants have you got and where from?

 

I find these really easy to use, the hardest part is remembering to manually turn it on and off each day. Thank god for alarms on phones!!

 

I will list the plants later in week, as I cant remember them all now!!

  • Like 1
Link to comment
Share on other sites

looks very nice, good job, won't be long and you'll be trimming and selling/trading/giving plant cutting pack's ;)

  • Like 1
Link to comment
Share on other sites

Hey mate,

 

How did you managed to setup two tank in such a short period of time? I guess you must be flat out by now.

 

Did you cycle the tank for two to three weeks before putting in the plant? If not, I will suggest you hang the light higher/ dim it (if it is dim-able). Or else, your plant will start melting and algae will bloom starting from the second or third week.

Link to comment
Share on other sites

Hey mate,

 

How did you managed to setup two tank in such a short period of time? I guess you must be flat out by now.

 

Did you cycle the tank for two to three weeks before putting in the plant? If not, I will suggest you hang the light higher/ dim it (if it is dim-able). Or else, your plant will start melting and algae will bloom starting from the second or third week.

 

Ok, guess I didn't ask enough questions!

 

I set it up and planted same day, so guess I am expecting algae and melting soon!!!

 

The light isn't dimmable, but there may be a way to diffuse the light for the next few weeks.

 

Thank you so much for this valuable feedback.

 

Oh, and in answer to how did I set them up so quick, I am a bit of a hoarder of aquarium goodies, so buy stuff as I see it and don't throw it out if there may be a good use for it.

 

Luckily all tanks, lighting was here and ready to go. All online shopping done weekend before, and I had two whole days to myself going tank set mad!!

 

 

looks very nice, good job, won't be long and you'll be trimming and selling/trading/giving plant cutting pack's ;)

 

I hope they survive long enough to pass some on to others!!!

 

Somebody has been busy.

 

Hehe, the joys of being a procrastinator, you think about it for a long time, then BAM, done!!

Link to comment
Share on other sites

  • HOF Member

Great work Jamie. I am not good with plants but I would be stoked if that was my tank!

Link to comment
Share on other sites

Great tank man have you decided what livestock will be put into the tank

Link to comment
Share on other sites

Oh, and in answer to how did I set them up so quick, I am a bit of a hoarder of aquarium goodies, so buy stuff as I see it and don't throw it out if there may be a good use for it.

 

Luckily all tanks, lighting was here and ready to go. All online shopping done weekend before, and I had two whole days to myself going tank set mad!!

!

 

Every time when I setup a new tank or revamp a tank, it takes me at least 1 week to prepare all the layout material and plants. After that 1 to 2 days to setup a new tank and 3 to 4 days to revamp and tank. After that, I will be horizontal for one whole week. LOL!!! Either my body is utterly useless or you must be much younger than me. ;)

Link to comment
Share on other sites

Its amazing the power of caffeine and knowing I should be doing other things, i.e. housework and cooking.

 

I think it helps that, as I really don't understand aquascaping concepts yet, it was more important to get them all to fit in!! I did go overboard!!

 

And as I knew I was going to attempt it, I had time whilst driving to mentally arrange the plants beforehand. Thankfully the idea married up quite well to reality.

 

Also, I am running it in two light cycles on for four hours in morning, off for eight, then back on for a further five of an evening. I had hoped keeping it to short bursts may limit algae without distressing plants too much.

 

I forgot to stress that the canister that is on this tank has been running for over 18 months on another tank, so it is full of cycled media. Will that assist in limiting the algae and melt do you think??

Link to comment
Share on other sites

Don't do short burst, it does not help unless you change the temperature and do total blackout to fool the plant. It will cause more algae. You should keep it dim such that it could reach a maximum of 50% respiration and 50% photosynthesis. This will make the plant keep producing sugar and at the same time use the sugar and nutrients for growing.

 

The melting is usually caused by NO2 or excess NH3 (it is fine with a little NH3). You can't prevent it, unless you have a cycled tank.

 

If you keep your light dim enough, you will only have diatom bloom but just at area where nearest to the light; if your highest point is plant and they are doing well, diatom will not grow. However, if your light is strong, you will get GDA, GSA (high NO3), spirogyra (NH3 is not cleared by bacteria on time; sometime test kit can't tell), BBA (because you are injecting CO2; may help if you use warmer colour lighting) and Rhizoclonium (extremely high light and high NO3).

 

Daily dosing of PO4 will help you reduce green algae but will reduce plant's leaf growth. But too much will cause GDA and Cynobacteria.

 

Sounds like a lot right? To make it simple, keep the lighting low. In this way, you will be able to react to algae bloom faster before it takes over your tank.

  • Like 1
Link to comment
Share on other sites

Hehe, the joys of being a procrastinator planner, you think about it for a long time, then BAM, done!!

 

Fixed that for ya.

  • Like 1
Link to comment
Share on other sites

ShrimpyDaddy, Thank you! I will have to pay some more attention when I return home tomorrow and figure out the lighting to be more appropriate.

 

and

 

jayc, you are a miracle worker, I feel more organised already!!! lol

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Join Our Community!

    Register today, ask questions and share your shrimp and fish tank experiences with us!

  • Must Read SKF Articles

  • Posts

    • beanbag
      Update to say that after a few gravel vacs, front wall scrub, moss / floating plant trim, that the condition seems to have improved.  My current theory is that it is due to waste / debris management, where "stuff" like that brown mulm accumulates in the substrate and behind the HMF filters.  Maybe some tanks can somehow deal with it, but mine can't.  Also another experienced shrimper suggested that maybe those "shell bugs" don't just live on the shrimps but also in this debris.  Maybe this is the reason some tanks fail due to "old tank syndrome" where all they need is a good gravel vac? Also, I am guessing that plant trim helps too because now more of the nutrients and light go into growing algae instead of more plants? Well anyway for this tank I will try weekly water change and monthly gravel vac / plant trim.  For my next tank, I'm thinking of something like an under-gravel system where this mulm can fall down and I vac it out.
    • sdlTBfanUK
      Good to have an update and good to hear you are getting shrimplets, so hopefully your colony will continue and you may not get to the point where you have to cull some to stop over population. These type of shrimp only live 12 - 18 months so the adult deaths may be natural? If you have the time I would do weekly 25% water changes, adding the new water via a drip system and do some vacuuming clean of the substrate each week, even if only a different bit each week! See if that helps in a few months and if it does then stick with that regime? It should help reduce any build-ups that may be occuring!
    • beanbag
      Hello again, much belated update: The tank still has "cycles" of 1-2 month "good streaks" where everybody seems to be doing well, and then a bad streak where the short antenna problem shows up again, and a shrimp dies once every few days.  I am not sure what causes things to go bad, but usually over the course of a few days I will start to see more shrimp quietly standing on the HMF filter, and so I know something is wrong.  Since I am not "doing anything" besides the regular 1-2 week water changes, I just assume that something bad is building up.  Here's a list of things that I've tried that are supposed to be "can't hurt" but didn't prevent the problem either: Dose every other day with Shrimp Fit (very small dose, and the shrimp seem to like it) Sotching Oxydator Seachem Purigen to keep the nitrates lower Keeping the pH below 5.5 with peat Things that I don't do often, so could possibly "reset" the tank back to a good streak, are gravel vac and plant trim, so maybe time to try those again. One other problem I used to have was that sometimes a shrimp would suddenly stop eating with a full or partially full digestive tract that doesn't clear out, and then the shrimp will die within a few days.  I suspected it was one of the foods in my rotation - Shrimp Nature Infection, which contains a bunch of herbal plant things.  I've had this in my food rotation for a few years now and generally didn't seem to cause problems, but I removed it from the rotation anyway.  I don't have a lot of adult Golden Bees at this point so I can't really tell if it worked or not. Overall the tank is not too bad - during the good streaks occasionally a shrimp will get berried and hatch babies with a 33-50% survival rate.  So while there are fewer adults now, there are also a bunch of babies roaming around.  I guess this tank will stagger on, but I really do need to take the time to start up a new tank.  (or figure out the problem)
    • jayc
      If that is the offspring, then the parents are unlikely to be PRL. I tend to agree with you. There are very few PRLs in Australia. And any that claim to be needs to show proof. PRL genes have to start as PRL. CRS that breed true after x generations doesn't turn it into a PRL. Neither can a Taiwan bee shrimp turn into a PRL despite how ever many generations. I've never seen a PRL with that sort of red colour. I have on Red Wines and Red Shadows - Taiwan bee shrimps. So somewhere down the line one of your shrimp might have been mixed with Taiwan bees and is no longer PRL. It just tanks one shrimp to mess up the genes of a whole colony. 
    • sdlTBfanUK
      Sorry, missed this one somehow! The PRL look fantastic and the odd ones look part PRL and part Red wine/Red shadow in the colour. They are still very beautiful but ideally should be seperated to help keep the PRL clean if you can do that.  Nice clear photos!
×
×
  • Create New...