Jump to content
Sign in to follow this  
wayne6442

More project pice to bore you with

Recommended Posts

wayne6442
post-29-139909845649_thumb.jpgpost-29-139909845651_thumb.jpgpost-29-139909845653_thumb.jpgpost-29-139909845647_thumb.jpg BLUE PROJECT!

post-12-139909856532_thumb.jpg

post-12-139909856537_thumb.jpg

Share this post


Link to post
Share on other sites
Sprae

Nice blue cherry project you got here

Share this post


Link to post
Share on other sites
Dean

good to see you working on so many lines mate. how are you finding the blue gene transfer?

i have found in the past with the red cherry with blue gene that unless you get a male with good blue it doesnt really strengthen in color.

keep us posted on this as this is what shrimp keeping is about :)

Share this post


Link to post
Share on other sites
wayne6442

Thanks Dean, I am finding it hard to maintain this blue gene, the male tend to get clearerand opaque, but still sticking in there. I think that it will take some time yet, but like the orange one never knows what will pop up next.A couple of my males now that they are older have turned a darkish grey colour, don't know where this is going/ have to wait and see.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  



  • Must Read SKF Articles

  • Register today, ask questions and share your shrimp and fish tank experiences with us!

    Join Our Community!

  • Posts

    • sdlTBfanUK
      A very good question and one I will follow with much interest as I had a similar question a year ago in that would I need to replace the substrate when it stopped buffering with my Taiwan bee tank if all the water I use has the right parameters. Unfortunately I don't know the answer in my case as my heater stuck on and killed all my shrimps off so I am starting again, though I still wonder about the same issue, though I should have at least a year before the new substrate stops buffering.  A lot of big breeding companies that have hundreds or thousands of shrimp (cherry and bee) in each tank (big tanks admittedly) use bare tanks (for obvious conveniences) so I am guessing it will be ok! Hopefully someone who has done it may get back to this thread, but otherwise I would give it a go with a few, especially if you have a spare small tank etc and see how it goes? If you used buffering substrate before but were using RO mineralised water of ideal PH did you have a problem once the substrate lost its buffering ability? I am/was hoping that the substrate buffering wasn't really needed if the water going into the tank is always around PH 5 or 6?  Simon
    • Myola
      So here's the thing. I've got 6 bare-bottom neo tanks that have been chugging along just fine for quite a while now. There are lots of babies and it's extremely rare to have any deaths, even when I add new shrimp.  I use remineralised rain water that has been filtered through an RO. I stopped using substrates in the tanks after I had ongoing issues with it breaking down, and to be honest, I wouldn't go back. Now I want to start some caridina tanks for tangerine tigers, CRS and blue bolts but want to know if I can get away with bare bottoms in them too. My RO filtered rain water comes out at pH 5, and when I add Salty Shrimp 'Bee shrimp' minerals to give me a GH of 5, the pH goes up to around 5.8. Do I really need the buffering affects of a substrate if my water is already within an acceptable range for caridinas? 
    • jayc
      It must have been an aluminium heatsink. The Indium in Liquid metal will eat through aluminium. Only copper or nickel plated heatsinks can be used with liquid metal. It says so on the packet, at least my pack of Thermal Grizzly Conductonaut does.
    • jayc
    • kms
      I will try to add all the old tank's shrimps at the end of August to the new tank, had a problem with my chiller this morning, try to make it more efficient by adding a better heat sink grease, I added a liquid metal grease, apparently you can't add liquid metal, when heating up, the heat sink turning to dust, along with part of the cooler inlet and outlet. So far the shrimps are ok.    
×