Jump to content
Sign in to follow this  
daimen

The best (so far)

Recommended Posts

daimen

20140621_121625_zps5ff65966.jpg

This is my best so far I'm trying to get some better males from somewhere. I really want the whole body a solid red. But I suppose I'm getting there

  • Like 2

Share this post


Link to post
Share on other sites
andy-Eco-tank

Looking good.

How long have you been trying for the full red?

So I no how long I'm looking at.

Share this post


Link to post
Share on other sites
daimen

I started with pretty good stock so it hasn't taken that long maybe 5 or 6 culls to get where they are

  • Like 1

Share this post


Link to post
Share on other sites
OzShrimp

Good looking female, i have always noticed that it is extremely hard to get good males as most breeders keep them for that reason.

Hope you manage to get a good male for her

Share this post


Link to post
Share on other sites
Squiggle

Very cool dude, good luck getting a couple of nice males. :thumbsu:

Share this post


Link to post
Share on other sites
daimen

Yeah my males are not the best but I'm getting these reds from maybe 80% of each group I only have to cull about 1 or 2 females from every 10

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Must Read SKF Articles

  • Join Our Community!

    Register today, ask questions and share your shrimp and fish tank experiences with us!

  • Posts

    • sdlTBfanUK
      I'm probably the wrong one to answer this???? Do as JayC stated and only use half dose every 2 days of the fluval cycle. I believe you only need to do a water change if the ammonia goes too high (so remove some ammonia)! I imagine that that product does add ammonia as that is the start of the cycle? The other reason for doing a water change is if the PH drops too low (below 6.5ish) but I doubt this is likely with your high PH reading, at this point anyway! Soil substrates usually lower/buffer the PH but I assume you are using sand or gravel, which is usual with cherry shrimp?  The Indian almond leaves and driftwood should very slowly reduce the PH, though the driftwood isn't yet in the tank of coarse! Hopefully the tank will have already cycled by the time the driftwood is ready to  go in the tank anyway. Simon
    • Brando
      Hi guys thank you for your help.    So i will add the driftwood to lower PH, and add fluval cycle once every 2 days with shrimp in aquarium. Should I do frequent 10-25% water changes if ammonia gets higher from the fluval cycle? I think I might of read somewhere that it will raise the ammonia. Best, Brandon
    • sdlTBfanUK
      As long as the shrimps are active and healthy looking then I think you are ok for now and just carry on trying to 'cycle' as per JayC recommended. There isn't much more you can do without ALL the parameters anyway. Even the strip ones are better than none! But at this point if the shrimp look healthy and active you don't need to stress, just enjoy watching them doing their thing! It would be interesting to know more about the tank and setup if you have time? Simon
    • Crabby
      Okay, great. Yes, it will, so do this. Soak first though in dechlorinated water (warm or boiling if possible) like Simon suggested, to remove any nasties.    They're okay, but we do want to be slowly fixing them. Step one is driftwood for pH, step two is cycling the aquarium for Ammonia, Nitrite, Nitrate.    If you can, please purchase one. There is a good one made by API, quite cheap, will last a while and easy to use/read. This is very important to shrimp. Here it is from aquarium co-op: https://www.aquariumcoop.com/products/api-gh-kh-test-kit-combo
    • Brando
      I have tested high Ph it is 7.6. I do not have a FH/kh testing kit either. Adding the wood would lower the ph a little right? Also, are the parameters I mentioned in my original post safe enough right now. Obviously I want to try and get them a little better!
×
×
  • Create New...