Jump to content

DIY fish cave


lachie1998

Recommended Posts

Hi Guys

I came up with this little cave thing for my female red dragon to hide from the male when he gets agro.

1. Buy a pot, the pot i used is 23cm across.

IMG_1539.jpg

2. Soak the pot in water for 5 minutes to soften the pot.

IMG_1540.jpg

3. Use a pencil to mark how big you want your entrance to be.

IMG_1542.jpg

4. Get a hack saw and cut your marked lines.

IMG_1541.jpg

5. Use a hole saw to finish off the entrance, the hole saw will make a arch at the top of the entrance.

IMG_1543.jpg

6. File off the edges so there will be no harm done to your beloved flowernorn.

Here is the finshed product:

IMG_1544.jpg

It is big enought for the female to fit in but not the male so she can escape from him if need be.

Cheers Lachie

Link to comment
Share on other sites

coll idea mate, so many interesting and different ways to do things with DIY. i use do do the exact same thing for my bristle nose when i had them years back.

Link to comment
Share on other sites

How did you find it on the saw blade?

I cut a couple in half to make BN caves and found that after each pot the saw was pretty much done.

Link to comment
Share on other sites

a 4 inch grinder with diamond blade worked for me best and fastest lol i never tried the hacksaw way as im to lazy :)

Link to comment
Share on other sites

a 4 inch grinder with diamond blade worked for me best and fastest lol i never tried the hacksaw way as im to lazy :)

I tried the dremel and ran through about 10 discs on that too :beaten:

Eventually resorted to cracking them with a cold chisel and using a belt sander to flatten them out

Link to comment
Share on other sites

the dremel are only good for little cuts and Handy man stuff. the dimond blades on the 4 inch greinder are made for cutting tiles and stone etc very easy and fast. those dremel blades cost a small fortune :) could buy a cheap grinder and blade from bunnings for the price of 10.

Link to comment
Share on other sites

I'm tempted to buy a tile saw there are cheapo ones for <$150 figure it would pay off itself pretty quick.

-Sorry for hijacking your thread Lachie - I'm off to to go watch a beer pong tournament so I wont annoy anyone any more tonight

Link to comment
Share on other sites

-Sorry for hijacking your thread Lachie - I'm off to to go watch a beer pong tournament so I wont annoy anyone any more tonight

Its fine, these are very good questions.

:)

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Join Our Community!

    Register today, ask questions and share your shrimp and fish tank experiences with us!

  • Must Read SKF Articles

  • Posts

    • beanbag
      Update to say that after a few gravel vacs, front wall scrub, moss / floating plant trim, that the condition seems to have improved.  My current theory is that it is due to waste / debris management, where "stuff" like that brown mulm accumulates in the substrate and behind the HMF filters.  Maybe some tanks can somehow deal with it, but mine can't.  Also another experienced shrimper suggested that maybe those "shell bugs" don't just live on the shrimps but also in this debris.  Maybe this is the reason some tanks fail due to "old tank syndrome" where all they need is a good gravel vac? Also, I am guessing that plant trim helps too because now more of the nutrients and light go into growing algae instead of more plants? Well anyway for this tank I will try weekly water change and monthly gravel vac / plant trim.  For my next tank, I'm thinking of something like an under-gravel system where this mulm can fall down and I vac it out.
    • sdlTBfanUK
      Good to have an update and good to hear you are getting shrimplets, so hopefully your colony will continue and you may not get to the point where you have to cull some to stop over population. These type of shrimp only live 12 - 18 months so the adult deaths may be natural? If you have the time I would do weekly 25% water changes, adding the new water via a drip system and do some vacuuming clean of the substrate each week, even if only a different bit each week! See if that helps in a few months and if it does then stick with that regime? It should help reduce any build-ups that may be occuring!
    • beanbag
      Hello again, much belated update: The tank still has "cycles" of 1-2 month "good streaks" where everybody seems to be doing well, and then a bad streak where the short antenna problem shows up again, and a shrimp dies once every few days.  I am not sure what causes things to go bad, but usually over the course of a few days I will start to see more shrimp quietly standing on the HMF filter, and so I know something is wrong.  Since I am not "doing anything" besides the regular 1-2 week water changes, I just assume that something bad is building up.  Here's a list of things that I've tried that are supposed to be "can't hurt" but didn't prevent the problem either: Dose every other day with Shrimp Fit (very small dose, and the shrimp seem to like it) Sotching Oxydator Seachem Purigen to keep the nitrates lower Keeping the pH below 5.5 with peat Things that I don't do often, so could possibly "reset" the tank back to a good streak, are gravel vac and plant trim, so maybe time to try those again. One other problem I used to have was that sometimes a shrimp would suddenly stop eating with a full or partially full digestive tract that doesn't clear out, and then the shrimp will die within a few days.  I suspected it was one of the foods in my rotation - Shrimp Nature Infection, which contains a bunch of herbal plant things.  I've had this in my food rotation for a few years now and generally didn't seem to cause problems, but I removed it from the rotation anyway.  I don't have a lot of adult Golden Bees at this point so I can't really tell if it worked or not. Overall the tank is not too bad - during the good streaks occasionally a shrimp will get berried and hatch babies with a 33-50% survival rate.  So while there are fewer adults now, there are also a bunch of babies roaming around.  I guess this tank will stagger on, but I really do need to take the time to start up a new tank.  (or figure out the problem)
    • jayc
      If that is the offspring, then the parents are unlikely to be PRL. I tend to agree with you. There are very few PRLs in Australia. And any that claim to be needs to show proof. PRL genes have to start as PRL. CRS that breed true after x generations doesn't turn it into a PRL. Neither can a Taiwan bee shrimp turn into a PRL despite how ever many generations. I've never seen a PRL with that sort of red colour. I have on Red Wines and Red Shadows - Taiwan bee shrimps. So somewhere down the line one of your shrimp might have been mixed with Taiwan bees and is no longer PRL. It just tanks one shrimp to mess up the genes of a whole colony. 
    • sdlTBfanUK
      Sorry, missed this one somehow! The PRL look fantastic and the odd ones look part PRL and part Red wine/Red shadow in the colour. They are still very beautiful but ideally should be seperated to help keep the PRL clean if you can do that.  Nice clear photos!
×
×
  • Create New...