Jump to content

wanna upgrade my tank...


ssophi80

Recommended Posts


Hi everyone, I am looking to upgrade my tank to a larger size and need some advice. Can anyone tell me which is better, acrylic or glass and why? And here's the big one- I'm trying to find a stand that looks good and is sturdy. I see a lot of nice looking stands out there, but when you read the fine print they are made of particle board. To me, that just seems like a disaster waiting to happen! Does anyone know where I can find a good stand in the Birmingham, AL area? I'm looking at getting a tank in the 50 - 70 gallon range. Thanks!

  • Like 1
Link to comment
Share on other sites

The easiest way wouod be to go to an aquarium shop and get a tank with a cabinet made for that tank, as that should be able to support the weight, as water in any large quantity is very heavy. I suspect it would have to be a glass aquarium at that capacity, otherwise the plastic would have to be very thick.

It is possible to use a non aquarium specific piece of furniture but as you say it is quite risky, though I did help a friend do that by strengthening a nice decorative piece of furniture they had that they wanted to put a 350L tank on. It has been doing the job for 10 years but also bear in mind water marks, and we had to varnish many coats to make sure water doesn't soak into the wood etc. Its not really worth it in reality, it cost a lot of money to buy all the wood/stuff to strengthen it so was probably no cheaper, and a lot of time doing it.

It may be dearer to get a combo tank and stand but much much easier and safer, and only you can know what ones you llike the appearance of? I would start off going to local stores and seeing if they have any you like, and even if not it will give you ideas?

  • Like 1
Link to comment
Share on other sites

8 hours ago, ssophi80 said:

Does anyone know where I can find a good stand in the Birmingham, AL

Sorry, I'm not in that area. 🙃

 

I prefer Glass tanks. Acrylic scratches way too easily. Often while cleaning algae off the sides. And once it's built up enough scratches, viewing gets obstructed. 

 

Often going with LARGE tanks, you start to fall into custom built stands. So don't be surprised if you cannot find anything suitable. 

 

Edited by jayc
  • Like 1
Link to comment
Share on other sites

  • 5 months later...

For beginners and smaller tanks, I recommend glass aquariums because of their affordability and scratch resistance. For larger, more advanced aquariums, we recommend acrylic because it's lighter and easier to repair than glass.

Edited by Moul1974
add more infomation
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Join Our Community!

    Register today, ask questions and share your shrimp and fish tank experiences with us!

  • Must Read SKF Articles

  • Posts

    • jayc
      It might be easier if you can tell us what substrate you have access to. We could list items that you can't buy or find.
    • sdlTBfanUK
      The substrate I used with some success is not available anywhere. When I retried with the shrimp king substrate it didn't work but I can't be completely sure the substrate was the cause of the failure, but I won't use that one if/when I try again! Here is a link to my usual suppliers active substrates so you can see what is available in the UK. I would recommend you get a different one to the one you have tried, but it probably isn't that that is the problem if it is made specificaly for shrimps and/or plants. Many active substrates require a 'run-in' period of some sort before adding creatures so you will need to bare that in mind - you can probably just do that first part in a bucket?  If unsure you could call ProSchrimp and ask what they use themselves? https://www.pro-shrimp.co.uk/55-active-substrate Usually bleach would be used to clean the tank and anything else in the tank, but obviously you will need to be sure to remove all traces of that before setting the tank up again! If you are going to start again then you should try some different GH+, one specifically made for shrimps, I use the shrimp king as below but there are others like salty shrrimp (pro shrimp seem to be out of stock of these, but you could call them). If it is shrimp specific then it will always be the perfect ph/gh/tds balance when used with RO water! https://www.pro-shrimp.co.uk/shrimp-king/803-shrimp-king-mineral-fluid-double-gh-4001615061413.html Is your taiwan bee tank still doing ok? If so, are the water parameters in the usual range in that tank as you were having something throwing them out in the CRS tank if I recall correctly? If you are getting new shrimp then try from a different source as it may be they were poor quality? ProShrimp do sell them, but if you are resetting the tank best not get new ones for a few months. If the taiwan bee are doing well and the tanks were set up the same then logically it may be the shrimp? https://www.pro-shrimp.co.uk/crystal-bee-shrimp/482-10-crystal-red-bee-shrimp-a-s.html Sorry to hear you are still having problems, I just hope the taiwan bee tank is at least doing ok.
    • herrwibi
      Hi all, Posted a few times with my CRS dying and it hasn't stopped. Tried to do several big slow water changes but no success. Looking to reset the tank and start again . What soil does everyone use and what should i use to clean the glass to make sure i kill anything that's on the glass etc. Potentially looking at Bluebolt's but i'm determined to crack CRS. Thanks. 
    • Subtlefly
      Thanks for the tip!
    • sdlTBfanUK
      A tip for using the glue is dry the wood/rock as much as possible then put a dollop/bead (or 2) of glue where you want to attach the plant on the wood/rock, then hold in situ for a few seconds, all done in a few seconds and no mess! The bead/dollop can be quite large as it dries clear so won't be visible! This is much easier, and less messy than trying to put the glue on the plant.
×
×
  • Create New...