Jump to content

safe phophate levels


xrayguy

Recommended Posts

hi guys, I've had climbing phosphate levels, roughly 2.5, which is higher than I'd like.  My tank is heavily planted.  I only feed every other day if that, and don't over feed ( i feel, fish eat most of the food within 5 minutes).

What I'm wondering, is there a level of phosphates that I need to be aware of, ie gotta do a w/c NOW.

thanx

r

  • Like 1
Link to comment
Share on other sites

Phosphate levels of 1.0 ppm (mg/L) or higher, the conditions become favourable for algae growth. At 2 to 3 ppm, algae overgrowth is likely to occur. Ideal phosphate levels are 0.5 ppm or less for an algaeless tank.

It's unlikely to be harmful for the fish and shrimps, it just encourages algae.

So it depends if you want some algae in the tank or not.  2 - 3ppm is probably still okay, certainly a trigger as a reminder to perform water changes. Maybe 4 ppm is a trigger for a water change NOW (if you don't already have overflowing algae) !!

If you do your weekly water change, phosphate levels should be under control. It's when you get lazy that issues develop, and with parameters that matter more than phosphate. 

  • Like 1
Link to comment
Share on other sites

i do a 50 percent w/c weekly, usually every tuesday.  That's why I'm perflexed.  I just wanted to make sure I wasn't harming my shrimp.  

I can only speak for myself, but I don't really want to grow algae.  So I pay attention to my water parameters, I keep a journal.  I test my water before dosing ferts.

 

  • Like 1
Link to comment
Share on other sites

5 hours ago, xrayguy said:

i do a 50 percent w/c weekly, usually every tuesday.  That's why I'm perflexed.

Hmm, now I'm perplexed. Do you use tap water? Test the water source for phosphates.

Phosphate is added to our tap water for a few reasons, and your local area might be adding more than other towns/cities.

 

Are you fertilising the tank? Most macro fertilisers have Phosphorus in it along with nitrogen and potassium.

Edited by jayc
  • Like 1
Link to comment
Share on other sites

0.25 out of the tap.  I thought it might be coming from equilbrium, but many people on another site don't think that's the cause.

 

  • Like 1
Link to comment
Share on other sites

3 minutes ago, xrayguy said:

0.25 out of the tap.

That's normal.

 

3 minutes ago, xrayguy said:

I thought it might be coming from equilbrium

Equilibrium has no phosphorus. Are you sure you have no other source of phosphorus coming into the tank, like fertilisers?

Aim for :

1 part phosphates to 10 parts nitrogen.
Since many planted tank aquariums have Nitrates NO3 in the range of 5-20 ppm, this means the phosphates should be around 0.5 to 2 ppm

Plants need Phosphorus, and use it along with Nitrogen and Potassium.  So maintain it around 1 - 1.5ppm to avoid algae issues, but still have enough for healthy plants.

  • Like 1
Link to comment
Share on other sites

I do use ferts.  I dose flourish ( I under dose), nitrogen, potasium and iron.  I test my water before dosing.  I've been dosing the same for months if not years, with the exception of using the equilibrium again.  I just started using that to raise my GH for my snails.

r

  • Like 1
Link to comment
Share on other sites

2 hours ago, xrayguy said:

I dose flourish

That doesn't have phosphorus either, not enough to raise it by that much.

The only other source is dead plant material or rotting food particles settled either in the substrate or within the filter.

Clean out half your filter sponges and "try" to gravel vacuum as much as possible. I noted that you have a heavily planted tank, and gravel vac can be hard without disturbing the plants.

  • Like 1
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Join Our Community!

    Register today, ask questions and share your shrimp and fish tank experiences with us!

  • Must Read SKF Articles

  • Posts

    • sdlTBfanUK
      It has been a few weeks now and I have done a couple of large water changes. I tested the water parameters this morning, GH6 and KH2, TDS 140 and PH 7.5. Obviously the PH is off but there isn't anything in the tank that should cause the PH to rise to this figure so I will just run the tank for another month with 10% weekly water changes (probably just with RO water) and see where we are at that point. The RO water tests at PH6, and the KH and GH in the tank could come down as they are at the upper limits for Caridina shrimps! There are only about 10 very small snails in there at this point, but they seem to be doing well enough.
    • sdlTBfanUK
      I believe these to be very rare in Australia so you may even consider making it a longer term plan and produce your own by starting with the best CRS you can get as that is where the pure lines started! Depends how patient and interested in the project you are, but would save money as well? If I recall correctly it takes from 8 generations of selective breeding? They sell them at micro aquatic shop but do not ship to Western Australia, but that means they are available in Australia. https://microaquaticshop.com.au/products/pure-red-line-grade-ss-shrimp Good luck and just maybe smeone on here may point you in the right direction or be able to supply you with some.
    • Jimmy
      Hi Guys,  Does anyone know where to buy PRL shrimps in WA, not the CRS please. Thanks Regards  
    • Subtlefly
      Yes it’s super accurate to position where I want now and stay there- I am satisfied.  All the fish and shrimpers are doing excellent! Coming up on 4 years running!
    • sdlTBfanUK
      You must be pleased with that, it looks better and is much more robust and less likely to damage or leaks! The tank looks very natural now it has been running for a time. I see the ember tetras, how are the blue shrimp doing, I see a few? The cat and dog look very content and unimpressed, lol.
×
×
  • Create New...