Jump to content
GotCrabs

Hi Again

Recommended Posts

GotCrabs

@jayc, HUGE help man, thank you, massive help.

Heard back from an aquarium store in Adelaide, am going to go ahead and get the Aqua One Aquanano 40, it's on special also, just need to shrimp proof the in take now, any ideas peeps? I was thinking a thin filter sponge over the in take, but not too pleasing on the eye though is it.

Share this post


Link to post
Share on other sites
GotCrabs

OK, after some opinions, I can get an Aqua One Aquanano 40 from Adelaide, just not 100% sold on the filtration of the system though as I swear by canisters, do I run with this system or go with a tank and add a canister? This tank will be only planted with say around 50 at most shrimp, so not much of a load in there, Aquanano 40 is 55 litres.

Share this post


Link to post
Share on other sites
Kaylenna

Just curious... but if you don't really like the filtration system, you were thinking of replacing the light, and you'll need to adjust the intake to be baby-shrimp safe.... why get a pre-packaged all-in-one system?  

Share this post


Link to post
Share on other sites
jayc
1 hour ago, GotCrabs said:

Aqua One Aquanano 40

The built in filtration system is going to be much better than an air driven sponge filter, and will be suitable for shrimps. You don't need a canister filter. 

I only suggested a canister filter for a tank without a built in.

+1 to what Kaylenna said. If you are only going to grow mosses, don't change the lights. 

 

Edited by jayc

Share this post


Link to post
Share on other sites
GotCrabs

Was planning to have Anubias, Bolbitis and Mosses in the tank, no other plant life other than that.

Went outta town today and sussed out a Aqua One Horizon 65, only thing is I didn't want the stand and wasnt keen on the hang on back filter either, he wouldn't sell without the stand.

4 hours ago, Kaylenna said:

Just curious... but if you don't really like the filtration system, you were thinking of replacing the light, and you'll need to adjust the intake to be baby-shrimp safe.... why get a pre-packaged all-in-one system?  

Yeah true, but just not too sure of what to go with at the moment.

Share this post


Link to post
Share on other sites
GotCrabs

Really like the all in one system, small, built in at the back, decently priced, just undecided, don't want to throw cash at something then change my mind.

Share this post


Link to post
Share on other sites
GotCrabs

Plus, I've really taken a liking to nano tanks as well, not too keen on larger tanks no more, haha.

Share this post


Link to post
Share on other sites
GotCrabs

What are people's thoughts on Kaldnes K1 Media? Asking because I came across it while looking at some shrimp foods on Boss Aquaria and thought that if it's any good I'll order some at the same time as the foods.

Share this post


Link to post
Share on other sites
Madmerv
7 hours ago, GotCrabs said:

What are people's thoughts on Kaldnes K1 Media?

Not really appropriate for a small filter system. They need to be moving all the time as in a sump system to work to their full potential as they are designed to rub against each other and bump off old bacteria. For the greatest surface area you are better off with a noodle type ceramic media. Lots of conflicting info on them as to which ones are best and a lot of price difference to go with that. In my opinion, and free advice is worth just that, just look for one that is pourous to the eye not really tight, if that makes sense.

  • Like 1

Share this post


Link to post
Share on other sites
GotCrabs

Cheers Merv, will have a look around at other stuff.

Share this post


Link to post
Share on other sites
GotCrabs

Wouldn't believe it, went down to the local fish store this morning to sell off some Blind Cave Tetras that belonged to the old duck, they were getting too big for her little tank and she decided she wanted some Bettas instead, while down there I found a Ocean Free Nano Space 34l, $198 down to $80 due to it being a ex display tank, one of the glass legs was also disattached and sitting there, I thought to myself this is pretty much the same tank as the Aqua One Aquanano 40, except slightly smaller, asked if I could have it, they said no worries, gave me an extra $10 off due to the broken leg, so ended up paying $70 for a $198 tank which I'll turn into a shrimp nano.

Got 1 male Betta and 2 females plus 2 lots of Betta foods in a swap deal for the 7 Blind Cave Tetras, which is cool also.

Have set up the Mr Aqua 12g Bookshelf, given it a good clean, filter is running, still have the old media in there and some water, lazy I know, but that's all running again, have the 3 Bettas in the bag sitting in the water in the tank as well.

Once I have that all up and running for her, I'll look into making the OF Nano Shrimp safe, get some more media and put a small heater in the back section.

LED is 5.2w, yeah not enough I know but surely enough for Anubias, Bolbitis and Moss right? Powerhead is 480lph, had a play with it earlier and you can turn the flow up and down, so that has enough flow, thinking I'll get a SS mesh piece and fit in the back section to stop juvi Shrimp from getting through the intake slits, will also put some Frogbit in the back section also to get with water quality.

What do you think? Did well? Any advice?

Share this post


Link to post
Share on other sites
Madmerv

I think you did bloody well. Led should be fine for what you want. Are you planning to put the mesh at the intake or before the pump section?

  • Like 1

Share this post


Link to post
Share on other sites
GotCrabs

Yeah thinking I'll put the mesh on the inside of the back sump section, that way no juvi shimp can get through and it isn't an eye sore to look at, seeing it's in the back of the intake slits.

Will take my time setting it up though, just get bits and pieces as I go, not all at once and in a rush like I have in the past.

Share this post


Link to post
Share on other sites
GotCrabs

Change in plans, have gone back to the Mr Aqua 12g.

Ordered a BioPro 90cm LED this morning, bought 2 x 2kg Fluval Shrimp Stratum bags, I don't think it's quite enough so will add a little aquarium gravel first then cover with the stratum, ordered 3 x Anubias nana on driftwood, 1 x Bolbitis heudelotii, see what that all looks like and go from there.

Share this post


Link to post
Share on other sites
GotCrabs

Well 3 x Anubias nana on driftwood received this morning in the mail, all in excellent condition, some nice pieces, just waiting on a piece of Bolbitis heaudelotii, should have that tomorrow.

Heater added, set to 24c, filter loaded up with new and old filter media and set up, threw the old BeamsWork 90cm LED on, it's on it's last legs, just waiting on the BioPro 90cm LED to rock up, but doing the job until then.

Looking a little bare at the moment, the Anubias nana leaves are compressed down from being squashed in the mail, but should be fine and spring to life after a couple days, thinking maybe 2 more pieces of Anubias on driftwood, see what it looks like once the Bolbitis goes in though. 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Must Read SKF Articles

  • Register today, ask questions and share your shrimp and fish tank experiences with us!

    Join Our Community!

  • Posts

    • jayc
      It must have been an aluminium heatsink. The Indium in Liquid metal will eat through aluminium. Only copper or nickel plated heatsinks can be used with liquid metal. It says so on the packet, at least my pack of Thermal Grizzly Conductonaut does.
    • jayc
    • kms
      I will try to add all the old tank's shrimps at the end of August to the new tank, had a problem with my chiller this morning, try to make it more efficient by adding a better heat sink grease, I added a liquid metal grease, apparently you can't add liquid metal, when heating up, the heat sink turning to dust, along with part of the cooler inlet and outlet. So far the shrimps are ok.    
    • sdlTBfanUK
      I have had the new shrimps a week and have ordered some new ones(10) for delivery friday. There are probably at least 6 of the 8 alive (they may even all be alive still) but as the tank is so densely planted it is difficult to tell, but I saw 2 black and 2 red this morning, as yesterday, but I'm sure 1 red and  1 black weren't the same as the ones I saw yesterday so there are probably at least 6, if that makes any sense??? Anyway that will be it for now and I will just let the tank and shrimps do there thing once this batch are in there in a couple of days, and I can get back to the usual routine as was, before this unfortunate event wiped out the last lot. All parameters are good, including the nitrates now, but there are a lot of brown patches on the plants and moss balls still......... It all looks a bit drab and uninspiring and brown!!! I probably just need to be a bit more patient? I will do some maintenance tomorrow and a small 2L water change, then the new shrimps will go in on friday after acclimatising. The shrimps were totally uninterested in the spinach or shrimp lolly I put in at the weekend but I am assuming they have so much biofilm at this stage that that is keeping them busy and well fed and they are staying under cover until they get used to their new environment and this strange ugly monster that keeps peering in at them through the glass from time to time? I guess if some 100ft tall bloke kept peering through my window a few times a day I would be a bit nervous/reserved shall we say? I removed the spinach and the shrimp lolly and put the shrimp lolly in the betta tank and within minutes there were 10 shrimp on it so there was definitely nothing wrong with that shrimp lolly! Simon
    • jayc
      Traps don't work on hydra. Even with planaria, it is slow and it doesn't catch them all.
×